I did them with a 1,000 volt megger .
There are many companies that sell a bus duct. Examples of companies that sell a bus duct include South Land Electrical, Sailing Electrical, and BD Electrical.
busbar sizing & calculation
You need a Megger tester. With one lead attached to the winding and the other attached to the motor housing, the Megger sends a high voltage through the winding. The Megger reads the resistance, letting you know if there is a short to ground.
Megger the body and the earth point. It should be zero
The value of insulation resistance varies according to the type of CT and manufacturer. It is best to check with the manufacturer for acceptable values. The word 'Megger' is a registered trademark of Megger Limited. Megger Limited's product range includes insulation testers, relay testers, battery testers and many other electrical test and measurement products. Tony Wills, Applications Engineer, Megger Ltd.
The output from a utility generator is low-voltage and very high current (later stepped up to a high voltage for transmission). The high current requires very large conductors, and busbars enclosed in a bus-duct are the most practical way to accomplish this. Some generating systems also circulate coolant through the bus-duct to keep the bus bars from overheating.
By means of Megger Vidar or Vanguad VBT Series
It is measurement done by megger tool of measurement .
Usually a megaohmeter (or megger) is used to test high current feeder wires for ground faults before they are landed on a transformer.
Bus bars are actually simple conductor strips of copper using for connection between one system to another.for example transformer to panel. bus ducts are enclouser of that bus bar
While using megger we only have to see whether resistance breaksdown at the upper value mentioned. Since megger generates high voltage we can check whether breakdown takes place or not.Megger has a range from o to infinity.So it is not possible to find accurate resistance,hence it is used as an insulation tester