Hyundai Santa Fe 2.4 engine Is there a procedure for removing spark plugs particularly under the coils?

Answer 1

Here is the procedure for a 2002 2.4 engine. Tools needed: ratchet, at least a 6" extension, 10mm socket, 13/16" spark plug socket. With the 10mm socket remove the plastic shield from the top of engine, take note of bolt lengths when removing them, set aside. Next remove the brackets one on each side again 10mm, (bolt length) then remove brackets and black plastic cover over coils and plugs. Remove plug wires noting which coil they go to, do not pull on wires, but on the wire boots so the wires are not damaged. Remove the electric wires to the coils, push locking tab in center of connector while removing. Remove two 10mm bolts from each coil and pull coil straight up, mark coils so they go back in same holes. Remove spark plugs with plug socket. Make sure the gasket (washer) is still attached to old plug, if not, remove it with a wire with a hook on the end. Set gap on new plugs (approx .040), put anti-seize compound on plug threads and install. Put silicone grease on plug wire boots and reinstall coils and wires. Replace covers and brackets. Pat your self on back for a job well done.