It Sounds As If Your Motor Is Going Bad, Like The Bearings Are Going Out. Causing It To Take More Current To Run And Burning Up The Resistor. You May Also Have A Wire Not Making A Good Connection Which Would Cause It To Draw Excessive Amperage. I Would Check The Wiring Pluged Into The Motor To See If All Is Well. Then Proceed To The Blower Good Luck
The Blower Motor Resistor Pack is defective. Replace it.
The blower motor resistor circuit board has gone bad. Replace the blower motor resistor. I did Still dont work Try the fuses...Had the same problem and it was a blown fuse.
The Blower Motor Resistor Pack is defctive. Replace it.
Your wiring is probably messed up, happened to me. Locate the wires from the blower to the controls check them and replace as needed. Assuming no wiring problem check and replace the blower motor resistor.
You need a blower resistor. $50 part. About $140 to have the dealer replace.
There is a resistor pack operated by the fan switch. It has failed. You need to replace it.
have you checked the fuse if so then you will need to replace the resistor for the blower hig and low dettings have you checked the fuse do you have 12 volts to blower if so then you will need to replace the resistor for the blower replace the blower motor
If the resistor is alright why replace it.
How do you replace a fan blower resistor on a vauxal Corsa?
Replace the Blower Resistor which is located behind the glove compartment. This is a common problem.
It is most likely a bad blower motor resistor. Replace the resistor. If the problem continues, it could be the switch.
Blows on #4 only? I would replace the resistor. #4 speed by-passes the resistor.