try wiggling the wires at the blower resistor if don't work then tap on blower motor
Check connections at the blower motor, blower motor resistor and at the switch. You may find a melted connection.
Sounds like your Blower motor resister, it controls the voltage to your blower motor, controlling the speeds, if you always have it on high, med ect. that speed is more likly to burn out first
If the HVAC blower motor does not work on any speeds, I would suspect the motor or the switch is bad.
Replace the wiper circuit board. It went bad on both of our blazers. It isn't too expensive. Pretty easy to get to too.
Blown fuse, bad motor, bad blower motor switch, or a defective Blower Motor Resistor Pack.
if it doesnt work on 1 and 2 it could be a blower motor resistor but if it doesnt work at all check the fuses, relay and check voltage if it reads 12 v replace the motor
Bad blower motor? Blown blower motor fuse? Bad fan switch? Bad blower resistor pack?
clean the heat filters
Resistor or blower motor power module.
sometimes he trains sometimes he doesnt
check the blower motor resistor located on fire wall behind washer fluid tank
the blower resistor is bypassed on high. a direct path to ground. if high is the only operational speed the resistor is bad.