It probably is the best idea to remove the battery and keep it indoors on trickle charge if your not using the car for a while,it will keep the battery much happier.As to the car,it will not harm it sitting there with no battery,the clock wont work obviously! and if you have a radio with preset channels/memory,you will have to reset them when you install the battery,also if it has an anti theft code you will need to reset that,but most modern radios don't have that anymore as car security is so much better these days.I must stress though that you should top the battery up and charge it fully after you have taken it out,then charge it once a month,or it will die.You can get an Automatic charger that will keep it automatically fully charged and can be left connected 24/7 with little observation.
The Audi being so old will have little electronics in it,it will not cause any problems to leave it with no battery.
No, it will not damage the car at all, you will need to reprogram your radio when the new battery goes in though.
stop before 1 minute, or remove the battery
CARBURETED MODELS # Disconnect the negative battery cable # Remove the fuel inlet and outlet lines.Use two wrenches to prevent damage to the pump and connections # Remove the fuel pump mounting bolts and the pump and gasket
Leave the battery cover ON. It slows the temperature extremes that your battery is subjected to, faster variations result in less battery life.
Just simply remove mounting bolt and cables and remove old battery under hood. There may also be a battery under the passenger side mounted to the frame. You will need to remove the bolts holding battery case to frame. There are cables to prevent battery case and battery from falling. Once dropped done, remove both cables and mounting bolt for battery. Remove old battery and replace with new.
Never connect the ohmmeter's leads across a voltage.On an analog meter, adjust the zero before use.Turn your ohmmeter off when not in use, to protect against voltage drain.When your ohmmeter's battery is low, or your meter won't be used for a while, remove the battery to prevent damage to the meter from battery leakage.
The place where you charge the aino under it there is a little gab pull in it and you Will get to the battery.
Only remove the battery as a last resort, because removing it while it is on can possibly cause damage to your computer.
Usually to reduce friction and/or to remove heat from the surface to prevent damage by friction and/or heat.
Jewelry is usually made of highly conductive metals and could easily short across the battery terminals if the jewelry comes into contact with them.
How to remove battery cover to replace battery
Remove - battery cable Remove + battery cable Remove hold-down bolt on front bottom of battery tray Remove battery