answersLogoWhite

0


Best Answer

it should come right back up oull it with you hand and should be running because of the booster if not open the line again and it will suck air in it , but just do it to see if it frees it up . then re-bleed them all always do the one that is far away first , which wil be the pass side back then driverside back then pass side front and then of course the driverside front , always make sure the resivoir is full ,

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: I went to bleed my brakes and the peddle went all the way down and won't move on my 2001 dodge ram any suggestions?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What size wrench to bleed brakes on a 1998 dodge durango?

Either 7/16ths or 10mm


How do you bleed the brakes on 2000 dodge stratus?

you go to a mechanic, because this is probably the best advice you will get on the web.


What size wrench do you use to bleed the brakes on a 1998 dodge durango?

A 5/16 brake wrench


If you change a caliper on a 2004 dodge Dakota drivers side do you have to bleed the back brakes to?

Yes, I recommend you bleed all brakes starting at the RR then LR, then RF, and end at the LF. It may not be absolutely necessary but then again it may be. To be safe just bleed them all.


What size wrench do you need to bleed the front brakes on a 1997 dodge dakoda?

3/8 Allen wrench


How do you Bleed the brakes of a 1987 Dodge Dakota?

from the furthest caliper from the master cylinder. Start with that one and move closer.


Why wont your brakes pressure pump back up after you replaced your rear brake pads on a dodge ram 2500 series?

bleed your brakes there might be air in the lines or the brake booster is bad try to bleed all 4 brake 1st


How do you bleed the brakes on a 1997 dodge diesel?

It takes two people. # Suck the brake fluid out of the reservoir and replace with new fluid. # There is a bleed screw on each wheel, it looks like a grease zirk. Loosen the bleed screw and have someone push the break peddle and hold it. # Tighten the screw then they can release the breaks. # Repeat step 2-3 until the brake fluid is clean # Repeat on each wheel, refilling the break reservoir after each wheel. Do not get air in the lines either by sucking the reservoir dry or by releasing the breaks when the bleed screw is loose.


Procedure for bleeding ABS brakes system on a 1998 Dodge Dakota 4x4?

To bleed the ABS brakes on a 1998 Dodge Dakota 4 x 4, two people are needed. One person needs to pump the brakes while the other opens the bleeder and then closes it making sure all air is out of the system.


How do you change the brake fluid in a 2002 Dodge Durango?

Bleed the brakes, adding fluid until clean fluid comes out from all four tires.


Do you have to bleed all the brakes if you only change one brake line on a 2002 dodge grand caravan?

Always best to bleed both sides if you change a brake line. EG: Both front or both rear.


Does dodge caravan 1996 SE has ABS?

It was an option. mine does. just drive your van up to 30 mph and slam on the brakes and see if they lock up. if they do not lock up and you feel a vibration in the brake peddle you have abs.