The lamp in the top brake light of a Toyota Highlander can be replaced by the locating the light housing from the trunk. Find the light cover and remove it to access the lights. Replace the bulbs.
The taillights on a 1999 Kia Sephia are replaced through the cars trunk. Remove the plastic covers from the light housings and replace the bulbs.
To replace the light bulbs in the sun visor vanity mirror on a 1991 Ford Escort LX, the mirror will have to be replaced. This part does not have replacement bulbs readily available. If the bulbs are not working it is a problem with a fuse as these run off the battery and are on the same circuit as the interior lights.
Remove the tail light housing and replace the bulbs.
To replace the brake light bulbs on a VW Polo, pull away the carpeting in the trunk, unscrew the bolt holding the lights on, and disconnect the wiring. Replace the bulbs, put the wiring and bolts back, then replace the carpeting.
AnswerThe bulbs for the brake lights are usually separate from the normal tail light bulbs. Check and replace the brake bulbs first, and if they are still not working examine the fuses, switch and wiring.
There are no bulbs, it is a panel of mini-lights. You access this from the trunk area.
Typical halogen bulbs that screw into normal light sockets can be replaced with energy saving bulbs that operate at the same voltage.
Replace the signal flasher relay.
There are two (2) lights directly above the license plate. Each light has two (2) screws. Remove these screws and the covers. Lights pop out with little effort. Replace bad bulbs with size 194 lights. These are approx $2 at walmart or an auto parts store. Once bulbs are replaced, reattach covers with the screws and you should be good to go.
If a car's lights are not working properly, the fuses should be replaced. The light bulbs should also be replaced if needed.
Bulbs. All the bulbs are fed from the same fuse.
you have to remove the cover of the dashboard to replace the light bulbs
It's a real pain to replace! The bulbs can be purchased at just about any auto parts store, but you have to completely remove the dash in order to access and replace the bulbs. It's a common problem (and a terrible design...)
If you are talking about the rear taillighs only the corner lights have bulbs pull back the inner trunk liner at the corner behind the light grab the grey or white plug and twist to remove the bulb the rear tailights on the trunk have no bulbs they are neon and if it is out the whole light assemble must be replaced
Open the trunk....inside the trunk, on the back side are plastic covers that you can remove...there you will find your bulbs....find the brake light bulbs and remove them and replace them with new bulbs, then replace the covers. Don't forget about the 3rd brake light ...check it to see if new bulbs are needle. Also, if all of your brake lights aren't working...all at the same time...you might want to check your fuses. If replacing the bulbs and checking the fuses doesn't do the trick, the next step is to check the brake light switch above the brake pedal. And lastly...depending on the age of the car, and the last time you replaced your bulbs...you might want to check all those bulbs
The light switch.
Replace bulbs Check the fuse Check the stop light switch
Check, or even better replace, the wires.
To replace the brake light on a 2000 Pontiac Montana open the trunk to reveal the housing units. Find the lights and pull the bulbs out. Replace the units.
I prefer LED light bulbs.
I hate to ask , but did you check the bulbs ? The tail light portion may work fine , but the brake lights don't if both of the bulbs are bad .
There is a campaign on the brake bulbs for 2000-2003......If it hasn't been done you should get it done. The bulbs and sockets will be replaced.
It depends what lights you are talking about, most dash lights are just bulbs. However in the cluster for digital lights and the fog light acessories they are done by LED lights in which you can replace if you know the right voltage. There are a lot of dash lights, so IRepairing Dashboard LightsTake apart the dash (or area where the lights are burned out) and replace the bad bulbs with good ones.
How about a malfunctioning brake light switch