Yes, you need coolant around the sensor probe to have it function properly.
Back flushing on a cooling system is when you get all of the trapped air out of your cars cooling system. This will make your vehicle run better after you do it.
Blockage in the cooling system No or little fluid in the cooling system Radiator fan not working
yes
No, you cannot put Pepsi inside of your car's cooling system. This could seriously damage if not make your vehicle inoperable.
Hand tight
Have the vehicle running when refilling the radiator, or top off radiator after engine warms up, and thermostat opens (temperature gauge will drop). Some engines have a cooling system bleeder you can crack open and fill the radiator until coolant comes out of the bleeder. The bleeder is generally located at the highest point of the cooling system on the engine.
Yes. However, if in a laptop, you will have to make sure that the drive does not output too much heat. This could cause the computer to overheat and the drive to malfunction if the cooling system is not adequate.
The traction control system malfunction light is a warning light that indicates the tires are losing traction on the road. If driving in adverse weather when the light comes on slowing down will make it go out.
First check to make sure that the system has freon, if not then you will have a leak then check the electrical system................
put cooling system flush in the radiator and follow the directions but make sure the heater is on while you do it.it will clean both your cooling and heating systems.
they can cause your system to malfunction or it may make your system erase all or your data
The 2.5 Acura has several parts that make up the AC system. The compressor, condenser, cooling radiator, and the inside of the cab core along with the hoses and freon all make up the cooling system.