answersLogoWhite

0


Best Answer

counterclockwise

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: If flames are coming out of the carburetor which way do you need to turn the distributor?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What would make a dodge 250 with a 360 sputter and backfire?

Could be in need of a tune up Could have moisture inside the distributor cap Could be in need of a carburetor rebuild


Why does your 1982 Ford E350 van backfire?

Because you need to change the gas filter in the carburetor and you need to change the rotor and distributor. I did and the backfiring went away. Now it runs great


Which carburetor outlet do you use for hose from distributor vacuum advance chev 327?

you need manifold vacuum. Either on one of the intake runners or at the base of the carb.


Do you have to advance the timing on a 350 when a bigger carburetor is installedIf so how much?

You may need to turn your distributor a small amount, but you MUST adjust the air-fuel ratio.


Can you convert your daewoo racer to carburetor?

yes. need to buy / mod the intake manifold for the new carb. low pressure fuel pump. and carb. and the distributor iia. that's all.


Why is your 1982 Ford Bronco hard to start?

# Bettery discharged or low # Air filter clogged # Fault in fuel or electrical systems # Fuel not reaching the carburetor or injectors # Carburetor in need of overhaul # Distributor rotor carbon tracked and/or damaged # Choke control stuck or inoperative


What are the 1964 Chevy v8 tune up items?

Replace plugs, points, condenser, & rotor. Check distributor cap, plug wires, and replace as necessary. Check timing and carburetor and adjust if need be. Replace Fuel, & Air filter. Replace PVC valve if equipped.Replace plugs, points, condenser, & rotor. Check distributor cap, plug wires, and replace as necessary. Check timing and carburetor and adjust if need be. Replace Fuel, & Air filter. Replace PVC valve if equipped.


How do you change a motor from carburation to tbi?

you will need to replace the intake with an intake for a carburetor,install carburetor and replace the distributor with one which has a vacuum advance(a late 70's 305 or 350 will work well). you will also have to install an electric fuel pump for a carburetor (lower pressure than the fuel injecton). remove the relay powering the pump in the tank if the whole wiring harness is not removed.


1964 dodge dart stalls when coming to a stop or changing gears?

sounds like you need to either turn up the idle some or get the carburetor rebuilt.


Why is gas pouring out of the breather tube coming off the bottom of the bowl of my carburetor for my Yamaha raptor 660r?

you need to check the accerator pump. check for pin holes


How Hydrogen gas be installed in carburetor?

I need the information where to connect the Hydrogen Gas to the carburetor on what side


What 350's fit my 1969 c10?

Anything that's older then a 1986 will work, But you will need to change carburetor and distributor. Anything newer will need a computer and electric fuel pump plus oxygen sensors. It would be best to find a engine that is a 1978 or older.