you need to check the accerator pump. check for pin holes
some one answer please ineed to ride this weekend
The term "decanting" is used to signify pouring a liquid from a solid on the bottom of a container.
yes
bad seal in between your intke manifold and carburetor
bottom left-inlet bottom right-return top goes to engine bottom breather
Inside the bowl-like affair at the bottom of the carb.
bottom left is the inlet, bottom right is the return, top goes to the engine, bottom is the breather
There is a breather plate inside that has a small hole, if I remember correctly that little hole needs to be near the bottom. The plate can be installed upside down if your not careful then oil leaks.
That is the main jet needle valve.
underneath the seat where it meets with the bottom of the tank
okay you dissmount the carburetor from the engine said and the airbox side, remember where the hoses went, now take a screw driver take apart the float bowl (the bottom of the carburetor) if it smells like old gas, take the gas out of the bike, you then clean it with solvent and a wire brush, take apart the top housing dont lose the jet needle because you need this to keep the bike from flooding, and just clean it with the wire brush and there ya go :)
under the bottom of the footrest