need diagram of focus electric windows 1999
how do i replace a throttle cable on a 1988 ford ranger pickup
If the cable is broken you should replace it.
Buy the Cable , then remove the screws that hold the broken cable and attach the new cable back.
Usually it's a matter of unhooking one end of the cable from a post, and then unscrewing the bolt from another end of the cable.
Loosen the shifter cable not on each end of the shifter cable. The shifter cable will come off. Reverse the process to install the new shifter cable.
You generally can't replace the guide without replacing the cable. If the transmission still shifts easily, you don't need to replace the cable immediately (as in, it is not an emergency) however you should plan to replace it as soon as you can. yes you do there is no getting around it, sorry
If it is the gauge you have to pull the gauge cluster. If it is the cable you have to get under the car and replace it. It will be the only cable on the tranny. Good luck
If it is just the plastic handle broken, behind that is the cable that opens the hood. Just grab the cable with a pair of pliers and pull. You can probably just replace the inside handle and not have to run a new cable.
Replace the cable with a new one. Or the cable might provide you with a new one. Ask them for a service call.
If it is broken they cannot be repaired. You need to replace it.
Replace the cable.
the winders are cable operated. you must check if the cable and motor are OK if so then the nylon capture assembly is broken. Relocate the cable and tie into the correct position with light gauge galvanized fencing wire. test re grease reinstall there ! If saved 350 dollars!
See if you can locate the cable that goes to the lever on the front of the transmission and determine if that cable is broken. If you find a broken cable, replace it, if not you may have a serious transmission problem.
where your latch is broken at you can use a pair of pliers and pull the exposed cable wire and it should open best thing when u open it replace the cable wire
I tried to solder the cable end, butthe solderbroke twice when I put a wrench to it to tighten the nut. So, I am going to just replace the cable if I can find one. TLB
Dealer said cable is run through a steel tube. They had to cut tube to replace broken cable.
If it is broken and the hood closed take it to the body shop.
You will have to remove the door panel and replace the regulator assembly. In some cases it comes as an assembly with the motor.
Remove the cable housing from the rear of the speedo and pull the cable out, then take it loose at the trans and remove the piece that is broken off. Get a new cable and when reinstalling it grease it good with special speedo grease.
Replace clutch cable on sportsbike
Replace the regulator. Once the cable comes off, it's toast. That usually means there's a broken plastic guide. They cannot be purchased separately.
HOW DO I OPEN HOOD ON CAR WHEN CABLE IS BROKEN
How to replace spedo cable f250
It is the black cable on the battery. All GM ground wires are black.