answersLogoWhite

0


Best Answer

I would not recommend doing that. It would make it very difficult to change the liner down the road. Also, if you get Canadian winters, or a fluxuation in temperature , it is possible for the liner to shrink when it gets cold and pop out of the track where it sits. I would recommend getting T-Bead, or some other product that would wedge the liner in permanantly if you choose to do this. Tiles also tend to chip and break easily, aswell as need replacing after aging. Bits can fall into the pool and put a hole in the liner. Its just not functionally rational to do this.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: If you are putting a liner pool in the ground and want to tile over the plastic edge what can you use and how?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the difference between a beaded liner and an overlap liner for above ground swimming pools?

A beaded liner will have a thick bead or lip of vinyl around the top of the liner. This bead will fit into a track which is made to receive the bead at the top edge of your pool. To replace it you simply pull out the old one an insert the new. There is a little more to it, but as far as the bead is concerned that is all you have to do with it. Overlap liners are harder to install because there is no bead so you don't know where the correct height is. You overlap the liner over the top edge of the swimming pool and clamp it in place with a piece of plastic. A beaded liner is harder to measure but easier to install and a over lapping liner is just the opposite because you are constantly adjusting the plastic clamps.


How do you remove the rear bumper on a 2007 Ford S-Max?

Remove 2 screws securing each wheel arch liner and 2 screws behind each liner, 6 screws along top edge, 2 plastic nuts on bottom edge. Good luck, spradders.


How do you remove the rear bumper on a 2007 Ford S Max?

Remove 2 screws securing each wheel arch liner and 2 screws behind each liner, 6 screws along top edge, 2 plastic nuts on bottom edge. Good luck, spradders.


What actors and actresses appeared in The Putting Edge - 2004?

The cast of The Putting Edge - 2004 includes: Michael Stasko as Ronson Carmichael


What ground clearance does the 2009 Ford Edge have?

The ground clearance of the 2009 Ford Edge is 0 ft. 7.9 in. (7.9 in.).


What ground clearance does the 2011 Ford Edge have?

The ground clearance of the 2011 Ford Edge is 0 ft. 7.9 in. (7.9 in.).


What ground clearance does the 2012 Ford Edge have?

The ground clearance of the 2012 Ford Edge is 0 ft. 7.9 in. (7.9 in.).


What ground clearance does the 2007 Ford Edge have?

The ground clearance of the 2007 Ford Edge is 0 ft. 8 in. (8 in.).


What ground clearance does the 2013 Ford Edge have?

The ground clearance of the 2013 Ford Edge is 0 ft. 7.9 in. (7.9 in.).


What ground clearance does the 2008 Ford Edge have?

The ground clearance of the 2008 Ford Edge is 0 ft. 7.9 in. (7.9 in.).


What ground clearance does the 2014 Ford Edge have?

The ground clearance of the 2014 Ford Edge is 0 ft. 7.9 in. (7.9 in.).


What ground clearance does the 2010 Ford Edge have?

The ground clearance of the 2010 Ford Edge is 0 ft. 7.9 in. (7.9 in.).