answersLogoWhite

0


Best Answer

I would NOT recommend leaving the pool drained all winter. If water froze in your hydrostatic relief pipes it could be the same as leaving them plugged. Further, moisture in the ground under the pool shell could freeze, expand, and "heave" the pool.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: If you were to drain your pool for winterization would it damage it even if there is a hydrostatic valve?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the hydrostatic drain valve?

The Hydrostatic valve is usually on the lowest part of the pools floor. The hydrostatic valve is there to protect the pool from being lifted by ground water in the event that it is empty. it allows the ground water under the pool to get into the pool thereby stopping it from floating out of the ground on top of the ground water.


Indoor pools can they have hydrostatic valve and can it break?

Any pool can have a hydrostatic valve and nothing has been made that cannot be broken eventually.


Will the hydra-static valve in main drain open if you empty the pool?

If it still works, it will open before the pool is completely empty. But are you sure the valve is hydrostatic? If it is not, then you will need to shop-vac the water remaining over the bottom drain, remove the drain cover, shop-vac the water under the cover, and then remove the lug nut and slide out the (manual) relief valve.


How do you replacement hydrostatic valve?

Very carefully


Drain very bottom of pool no working why?

Perhaps it is not a drain but a hydrostatic valve. These are fitted at the bottoms of pools to let ground water that has built up under an empty pool into the pool in order to stop it from floating out of the ground.


How do you turn on your pool drain?

I don't know about your pool I do know however that most pool don't have a way out for the water other then through the static skimmer. and people often mistake the hydrostatic valve at the bottom of the pool as the pool drain


Does the pool main drain-hydrostatic valve need to be connected to the skimmer box?

the hydrostatic valve is only to equalize pressure of ground water to that of the pool the only time it does anything is when the water table becomes higher in the ground water than in the swimming pool . it doesn't connect to anything. it is simply to keep the pool shell from floating out of the ground


I want to drain a pool to work on the re-plaster how long can I leave the pool empty?

For as long as you like just make sure that the pool has a hydrostatic valve or some other means to stop it from floating out of the ground if it starts raining or the water table underneath it rises. In gunite and concrete pools, the hydrostatic relief valve is located in the bottom drain. Sump or ShopVac the remaining water covering the drain, take out the screws, and remove the cover. Again, using a ShopVac, remove the water just beneath the cover and look inside the drain. There are two possibilities: 1) a relief valve that can be unscrewed and removed, or 2) a second pipe that doesn't point toward your pump and filter. Inside this pipe is a hydrostatic relief valve that probably won't open because of sand or dirt clogging it. Using the handle of a short screwdriver, tap the valve inside the pipe (you may not see it, but it is there) several times until water comes into the pool. There may also be hydrostatic relief valves near the bottom of the steep slope that can be removed. Good luck. -Bill


How do you drain your baseboard radiators?

If there is no drain valve at the radiator you can drain the system at the drain valve on the boiler


How much water should you leave in a swimming pool after you drain it?

If you don't have a hydrostatic valve on the bottom I would suggest at least a third. otherwise it may start floating in ground water if it is present.


how do you drain the how tub?

There should be a drain valve where you can hook up a hose and then open the valve to drain.


In a pool what is the white circle thing in the deep end?

This is the hydrostatic valve. If the pool is emptied it is removed to relieve water pressure caused by the surrounding water table If not removed a pool can float out of the ground.