The metal wheel on the long handle is called a tracing wheel. It is used with tracing paper to put marks from the pattern onto the cloth after the pattern pieces are cut out.
hand wheel
Remove the long access panel from the inside of the tailgate.Unhook the two metal rods from the handle on the inside of the tailgate.Remove the two bolts from the door handle located on the inside of the tailgate.
to make a sewing machine a year
because the longer the lever , the easier the job. this is because a longer lever gives bigger tuning effect.
The spool pin refers to the metal (or plastic) rib on top of, or on the side of the machine that you stick the spool of thread onto. It is usually about 2 inches long, and about 1/4 inch thick. It holds the spool securely while sewing.
As long as you want to but, it may put you in a dangerous situation where the car may handle poorly and you will wear out the tires prematurely.
a tracing wheel is a stick with a knotched circle on it. it was used with colored paper to mark lines on a fabric for sewing.
Any brand will do, as long as it has a timer and decent heat control for annealing glass, and can put out enough heat to handle the metal clay.
a wrenchn with a short handle because he will not have to move it through a long distance
The sewing machine gave people an alternative to sewing by hand. People stopped sewing by hand as much because now there was another choice. It meant that, especially for long, straight seams, there was a faster way to sew. Sewing machines are also more consistant.
Actually you can as long, as you don't handle them to long.
The wooden wheel is soaked or kept wet for an hour or so, not too long or it will swell and the joints come apart. The metal tyre is heated by turning it in a fire using tongs until it has expanded enough to fit over the wooden wheel. It is knocked down around the wooden wheel on the ground using a hardwood block and a four pound hammer. It is then cooled in oil.