instalation of f150 blower moter
which way does it mount?
it should be next to the blower motor
it is behind the glove box for the 2004-2008 F150 truck. There is a connector with four pins in it and this part is held in place with 2 bolts only. I is more on the right hand side of the blower motor assembly
The blower motor should be under the hood. It is on the passenger side and bolts into the back of the heater housing.
You have a bad blower motor resister..........
Blower Motor Resistor is bad. 20.00 part at AZ.
Blower Motor Removal & Installation With Air Conditioning 1. Disconnect the battery ground. > On trucks built for sale in California, remove the emission module located in front of the blower. 2. Disconnect the blower motor wiring at the blower. 3. Disconnect the cooling tube at the blower. 4. Remove the 4 mounting screws and pull the motor from the housing. To Install 5. Remove the clamp from the blower case and remove the blower cage. Mount the cage on the replacement motor. 6. Install the blower motor and tighten the 4 mounting screws. 7. Connect the cooling tube and wiring hardness. 8. Connect the negative battery cable. Check the blower motor for proper operation. 9. Cement the cooling tube on the nipple at the housing using Liquid Butyl Sealer D9AZ-19554-A, or equivalent.
Most likely and bad blower motor resistor.
The 2005 Ford F1 50 pickup truck blower motor resistor pack can be found on the firewall in the engine compartment. The blower motor resistor pack is on the passenger side of the firewall.
It's located inside the on the passenger side under the glove compartment. Also the blower motor is the same type for all F150 from 1997 to 2003. Allen Bouvier, Fort Simpson, Northwest Territories, Canada.
Blower Motor Removal & Installation With Air Conditioning 1. Disconnect the battery ground. > On trucks built for sale in California, remove the emission module located in front of the blower. 2. Disconnect the blower motor wiring at the blower. 3. Disconnect the cooling tube at the blower. 4. Remove the 4 mounting screws and pull the motor from the housing. To Install 5. Remove the clamp from the blower case and remove the blower cage. Mount the cage on the replacement motor. 6. Install the blower motor and tighten the 4 mounting screws. 7. Connect the cooling tube and wiring hardness. 8. Connect the negative battery cable. Check the blower motor for proper operation. 9. Cement the cooling tube on the nipple at the housing using Liquid Butyl Sealer D9AZ-19554-A, or equivalent.
It will be either defective fan switch, motor itself, blower motor resistor pack, blown fuse, or defective wiring. If the blower runs on high but no other speed, suspect the resistor pack.
yes