I just replaced my blower motor resistor in a 95 town and country. pretty easy its located on the fire wall passenger side. Facing the van, open the hood its top left almost under the hood hinge with the harness plugged into it. pull off the harness and the two screw bolts replace and your done.
The blower motor resistor is over the passenger side strut tower, under the hood.
A malfunctioning blower motor resistor will cause the blower motor not to work. When the resistor is bad the blower motors will not turn on.
Locate the resistor under the dash attached on the blower motor housing. Disconnect the wire harness connector. Remove the resistor and install a new one.
The a/c heater blower motor resister is located in the vehicle on the passengers side inside the housing next to the blower motor...............Remove the blower motor resistor wire harness connector.Remove the blower motor resistor screws.Remove the blower motor resistor.
Resistor is a separate unit from the blower motor
Locate the resistor under the hood near the blower motor on passenger side firewall. Unplug the electrical connector. Remove the screws holding the resistor in place. Remove the resistor. Install in reverse order.
Generally the blower motor resistor is found close to the blower motor. It relies on the blower motor to keep it cool.
The blower resistor is behind the glove box. It mounts to the HVAC housing.
The blower motor resistor has failed.The blower motor resistor has failed.
Fig 15 Blower Motor ResistorNOTE: The blower motor resistor is located on the lower right side of the heater housing.REMOVAL# Remove lower right underpanel silencer/duct. # Disconnect wiring connectors on blower motor resistor. # Remove blower motor resistor retaining screws. # Pull blower motor resistor out of heater housing.
The 1991 Honda accord blower motor resistor is located on the firewall in the engine compartment. The blower motor resistor will be on the passenger side of the firewall.
The blower motor fan cools the resistor so the resistor is usually located close to the blower.