answersLogoWhite

0


Best Answer

Simple answer..NO.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Is 250V a safe voltage for the 220-240v appliances in India?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can you plug a 330V appliances to a 250V current outlet?

The voltage of the supply and the appliance must be matched to avoid malfunction.


What is the voltage on a railway?

Overhead wires on the railways are 250v


How do you calculate ampere given 250v AC 60W?

Divide the watts by the voltage to get current (amps). 60W / 250V = about 1/4 Amp.


What is the potential voltage of each cell in a fully charged battery?

250v On an automotive battery it is 2.2V


Can you use a 125V 15A fuse to replace a 250V 10A fuse?

No, the voltage rating should not be exceeded. However, you could use a 250v 10a fuse for a 125v 10a fuse.


Should voltage going into home be 250V?

Its a bit on the high side, as measured between L1 and L2, but not a problem. Better for appliances than a low voltage. Lights will tend to be a just bit brighter and use a bit above rated power. Certainly a big problem if measured between either live conductors and the neutral.


Can you plug your phone with 120 voltage to 220 voltage in UK?

read the label on your charger if it says 90v to 250V it will be ok it it says 120V it will not be ok


Can the 2.2 microfared 250V capacitor be charged with 12V dc source?

Yes. The 250 voltage is a not-to-exceed rating.


Can you use a 250V 3.15A fuse to replace a 125V 3.15A?

yes. the 250v just means that's the maximum voltage rating the fuse can handle .. so it can def handle 125v. just not vice versa.


Can you use a 250v 3a fuse to replace a 125v 3a fuse for equipment voltage is 100volt?

Yes, fuses of a higher voltage can be used safely. What is not recommended is to use a lower voltage fuse on higher voltages.


Is the f5l 250v fuse similar to f5a 250v and f5al 250v?

nope


Can you properly switch prongs on a 20 amp 250v twist lock to change it to a 125v?

No, it is against the National Electrical Code to wire a receptacle with the wrong voltage. You should call a qualified electrician to change the 250V receptacle to a 125V receptacle.