Want this question answered?
is there a diagram or a picture of the distributor cap and rottor in a 95 ford probe gt 2.5lt
To set the ignition timing on a Ford Probe GT 95 with an MX engine, remove the two 12 mm head bolts holding the distributor in place. Then rotate the distributor to set the ignition timing.
1993 to 1998
NO SPARK TO DISTRIBUTOR CAR WILL TURN OVER BUT WONT START 95 FORD PROBE
i belive it is but just check the model number on the tranny and make sure they match just incase im wrong yes so it the entire engine assembly
Right out of the gate a 95 probe SE has 120 hp
im sure it is the cam sensor. No. OK Finally! My 95 Ford Probe mysteriously would not start. We then checked the resistance on the distributor, it did Not have resistance. ( My Distributor was still under warranty. After putting in a NEW Distributor, it still would NOT start. I then searched this website, and found other people had the same problem. (My husband is a mechanic and so is his best friend and they were both stumped). Next we replaced the crankshaft sensor, and WHOOPEE it started rite up!!! Its very strange that both the Distributor and the Crankshaft Sensor both went bad at the same time?? My husband thinks it is just a coincidence, but I think the Sensor made the Distributor go bad somehow...Only God knows: ) I you. Oh and P.S. my 95 Probe is for sale if you are interested. Its running perfect now. Has new; Brakes,Tires,Distributor,Spark Plugs, Catalytic Converter, Clutch, Re Upholstered seats, etc.....Was my son's but for discipline reasons he lost it. Chino, California Read more: Why wont your 95 ford probe start
Check you coil. Should have 12v on primary side with ignition switch in on position.
What can be the problem with the overdrive light flashing on and off?
Nope 98-94 is one model. 95 starts a new design.
The 95 SE has an hydraulic-assist clutch that is slaved off of the brake master cylinder.
I don't know if your 95 GT is anything like my 90 GL, but when I put my new plug wires and distributor in, the correct order was on the side of the distributor itself. If it isn't, it is in the ford probe repair manual, Haynes edition. You can get it at Autozone for 20 bucks. Seems like a lot for a manual, but sometimes it does come in handy. Hope this helps.AnswerI don't know if your 95 GT is anything like my 90 GL, but when I put my new plug wires and distributor in, the correct order was on the side of the distributor itself. Then take one plug wire at a time, and plug them in. If the correct order isn't on your distributor, you can find it in the ford probe repair manual, Haynes edition, available at Autozone. hope this helps.