no the higher the ohm the more resistance in the speaker
the lower the resistance the more power it will use
so if they are the same make the 4 ohm should be louder
4, the lower the better
You can, but you may damage your amp. If you wire them in parallel (both wires from each connected to the amp) then you will have an effective resistance less than 2 ohms. If you wire them in series then you will have an effective resistance of 6 ohms. Resistance that is too low draws more power than the output is rated for. Resistance that is too high reduces the volume and may distort the sound.
Remove the wiring harness from your 2001 Chevy Suburban sub woofer. Remove the sub woofer retaining bolts. Reverse the process to install your new sub woofer.
A Sub Woofer is a type of speaker, but the main difference between normal speakers and a sub woofer is in the range of sound it produces. A sub woofer produces the lower pitches that other speakers can't clearly put out.
A passive sub-woofer does work when plugged in to an amplifier. In an active sub-woofer ("powered") the amplifier is built in.
Sorry, but there is really no 4 ohm amplifier. We use only voltage bridging. The amplifier will have an output impedance of around 0.04 ohms. In hi-fi we have always impedance bridging. Zout
IT is a 8" sub woofer an there is only 1 located in the rear of the car on the passenger side.
You need to know how much power the sub woofers are rated to handle. Choose a power amp that can supply sufficient power.A power amp designed specifically for sub woofer use delivers all of it's power at the lower frequencies where a sub woofer operates. They may also have better cooling since they operate at higher power than full range amps.
on factory actor on usa or on Europe the plaisio stores
The most expensive sub-woofer would cost around 2,000 dollars. The band of this sub-woofer would be JL Audio.
Yes unless you want to smoke your subs
If you are trying to pump a 2.4 ohm sub with a 2 ohm rated amplifier you should be fine. The rating on the amplifier is the least resistance it should have on its load. Anything less than 2 ohms would fry your amp.