No it is not advisable. Put it on AUTO. The furnace will decide when it is practical to turn the fan on. Really. No it is not advisable. Put it on AUTO. The furnace will decide when it is practical to turn the fan on. Really.
In Daniel 3:19 it says that the furnace was heated sevens times greater than "usual". There is no claim that it was seven times greater in heat than any other furnace.
On average, a furnace turns on about 3-4 times per hour during the colder months, depending on the temperature setting, insulation of the home, and the outdoor weather conditions. This could vary based on the size of the home and the efficiency of the furnace.
Its advisable not do it for more than 3 or 4 times a week
circuit board on goodman furnace blicking continously after try to start 3 times fire down led light
You take the size of your home in square feet and times it by how many rooms you have. A 70,000 BTU furnace will heat a house 1600 square feet.
From what I know the blower brushes are worn down. Easy fix just do a search for "replacing blower brushes on 85 Mercedes 300D ZaneRen
Bad ground or power wire on the blower.
probably a defective blower motor. not really, the blower works at all times
the blower motor has gone bad
Most likely is a short in the wiring from your heating/cooling/vent controls to the blower motor, or simply the blower is going bad.
Can you feel anything coming out of the vents. Also if you turn on the dial that controls the speed of the blower, and you dont feel anything coming out then you need a fuse or blower motor or mabe a resister for the blower motor. I would have to say that 8 out of 10 times its usually the blower motor resistor. Hope this helps
A lot of times people do not realize that the size of the extension cords used can negatively effect the electric item it is powering. I think he may have connected the blower using a smaller guage wire (of the extension cord) than he should have, causing too much heat at the plug and inside the blower. Probably the blower got too hot and the switch is defective and the only way he is able to keep it going is to hold the switch in the on position. If you are handy dismantle the blower and check the switch or replace, then I think, it will work.... also get an extension cord of equal gauge or larger.