No. See sources and related links below for wiper blade info.
If a windshield wipe arm is loose on a 2002 Chevrolet Blazer, it likely needs to be replaced. It probably has a broken connection.
Carefully take the trim off from around the windshield then very, very carefully cut the calk that is between the windshield and the frame loose.
A failed lift pump ( very common ) or a leak/break in a fuel line.
The rear view mirror on a 2000 is glued to the windshield. Very carefully it can be pried loose. It may be necessary to insert a thin wire or razor edge to break the seal.
Yes it will. The most common problem with the board is a loose terminal.Check it real close with your fingers and find the ones that are loose and then get a soldering gun and melt it back together. That should fix it.
Loose wire or bad connection to light.
spread
Sometimes the heat shields around the outside of the converter break loose or rust out and causes a rattle noise.
Worn, loose, or dry rotted. They just break with age.
because you used too much washing your windshield with your windshield wipers My best guess would be a cracked hose or loose connection at the bottom.
It shouldn't unless the battery connections were dirty or left loose.
On the Range Rover Mk III this is a common problem. If the noise is coming from the windshield/dash, its actually the wind hitting the bottom of the windshield -- the trim there is loose enough that Rover issued a TSB on the matter. Make sure the plastic exterior trim fits snug...