0
NO! It's feckin' easy. Remove plastic on steering column so you can get at the ignition. Watch for the little white and black plastic pieces holding it on. Once you have that off there should be a SMALL hole in the side of your ignition cylinder. Push something in there (small screwdriver, nail punch, whatever) and it should come right out Take it along with your new one to a locksmith if you want it rekeyed. You can start your runner with the cylinder out by using a pair of needle-nose and common sense. I did it in 20 min with a broken leg in Texas heat. ITS EASY.
What else can I help you with?
Replacing a ignition switch in the dashboard of a 1995 4- Runner?
pics of 1992 4runner ignition switch
How do you remove the ignition tumbler in a 1995 mercury tracer?
3 screws facing the engine
How to change the Ignition switch in a 1995 Nissan maxima?
http://forums.maxima.org/4th-generation-maxima-1995-1999/146706-how-do-i-change-ignition-switch.html
Why does 1995 Ford Escort LX not start when ignition switch clicks with key but engine doesn't turn over and instrument panel lights on without key in ignition and radio heater and lights work?
you need a new ignition tumbler.
Put a 1991 4runner motor in a 1995 4runner?
Typically, yes. Most 1990-1995 4runner's came with the same factory 3.0 V6 engine and are interchangeable.
Bolt pattern for 1995 4Runner?
If your asking for the bolt pattern on the Toyota 4runner. It is a 6 on 5.5.
How do change the ignition switch on 95 Chevrolet g20 van?
You can change your 1995 Chevrolet ignition switch by removing the ring at the top of the ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
How many shocks on the front of 1995 Toyota 4Runner?
2 shocks on the front of the 4runner. One on each side
How do you change the Ignition Control Module in a 1995 Blazer S-10?
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.
How do you change ignition control module 1995 Buick Riviera?
Disconnect the battery. Remove the ignition coils. Remove the ignition control module that was under the coils, and replace it.
How do you change a ignition on a 1995 ford f150 with no keys?
Well you could ram a flat head into the ignition and turn it to the on position then take steps
When I start my 1995 Pontiac Transport 3800 the heater fan and wipers do not work unless I turn the ignition key up.?
i would change the electrical part of your ignition switch- i would change the electrical part of your ignition switch-
