Remove wheels
Remove brake drums if so equipped
Axle shaft should be secured by 4 bolts accessible by hole in center hub
Remove these 4 bolts and axle should slide out of differential
Bring to an auto parts/machine shop to replace seals
Not necessarily the way to do it above:
Chock front wheels and raise rear wheels, remove wheels and brake drums, remove rear differential cover and drain fluid, spin left or right tire to achieve shear pin stop bolt, remove this bolt, and remove shaft gear pin, push in on left then right axle while c clips fall into pumpkin housing, remove axle shafts, remove rear axle seals from housing using the axle itself or a seal remover, and replace. Installation is reverse of removal. Don't forget to fill the diff. with fluid, some newer chevys take a special fluid fyi.
very carefully.
Yes they will as long as the 99 is not the new body style.
In the oil pan
You CAN"T.
It doesn't have one.
inside the distributor
.356's
Check your fuses.
Should be about 5500 Lbs.
mine was 25 gallons
there is a switch on the lever on the trans on the driver side
190 to 200 degrees is perfect. / NORMAL.