0
Is it important to use an ac adapter then a battery during installation?
Wiki User
∙ 16y ago
Yes, it is important to use an AC adapter than a battery during installation because you want to make sure you can complete the installation before the battery runs out.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
When installing Windows XP service pack 2 on a notebook computer why is it important to use an AC adapter rather than a battery during in the installation?
This is to prevent the notebook from running out of power during the installation process.
When installing windows xp service pack 2 on a laptop why is it important to use an ac adapter instead of a battery?
Because if that battery should run out of power during the installation, you will have to start over from scratch.
When installing Windows XP Service Pack 2 on a notebook computer why is it important to use an AC adapter rather than a battery during the installation?
you don't want the battery to fail you part way through the process.
When installing windows XP service pack 2 on a notebook computer why is important to use an AC adapter rather than a battery during the installation?
If you try to install software while using just battery power, the battery could run low affecting the installation. Use the power supply/charger to make sure that power to the computer is uninterrupted.
What step is critical to ensure that you do not lose important data during installation?
what step is critical to ensure that you dont lose important data during installation
How 94 corrado changed car battery now the alarm wont switch off any ideas?
Leave driver's door open when replacing the battery. It's when upon installation of battery, you open driver's door and the alarm activates, right? Leave door open during installation. Same goes when you are charging up the battery, leave door open.
Why is it important to have a battery back up?
It is important to have a battery back up and to check its power level at regular intervals. This way, in the event one's battery fails during a power outage, one is sure to be covered.
How do you know battery is fully charged in toshiba laptop?
Leave the laptop off. Allow the AC power adapter to fully charge the battery for 12 hours. During this time, do not use the laptop or turn it on. This can slow down the charging of the battery.www.laptoptown.com
Why the batery MacBook Pro 13 only lasts 3 hours i bought it one and a half month ago?
Apple recommends that:The battery needs to be recalibrated from time to time to keep the onscreen battery time and percent display accurate and to keep the battery operating at maximum efficiency. You should perform this procedure when you first use your computer and then every few months after that.The calibration procedure for Powerbooks and MacBooks (See links below):1. Plug in the power adapter and fully charge your PowerBook's battery until the light ring or LED on the power adapter plug changes to green and the onscreen meter in the menu bar indicates that the battery is fully charged.2. Allow the battery to rest in the fully charged state for at least two hours. You may use your computer during this time as long as the adapter is plugged in.3. Disconnect the power adapter while the computer still on and start running the computer off battery power. You may use your computer during this time. When your battery gets low, the low battery warning dialog appears on the screen.4. At this point, save your work. Continue to use your computer; when the battery gets very low, the computer will automatically go to sleep.5. Turn off the computer or allow it to sleep for five hours or more.6. Connect the power adapter and leave it connected until the battery is fully charged again.
What step is critical to ensure that you don't lose important data during installation?
Back up all of your important Data on a hard disk or solid-state memory device.
Does Windows 7 maximize user involvement during attended installation?
Windows 7 minimizes user involvement during installation. You only enter information at the very beginning and very end of the installation.
During you can create and delete partitons and select a partition on which to install windows xp?
During XP setup or installation, partitions can be created, deleted and selected for installation.
