Seat Belts and Safety Systems
Windows and Mirrors
Ford Crown Victoria

Is it possible to install a drivers side airbag in a 1989 Ford Crown Victoria LTD?

333435

Top Answer
User Avatar
Wiki User
Answered
2004-12-07 10:34:51
2004-12-07 10:34:51

Yes it is but you have to find someone willing to do it as it is a job that rrequires a good bit of understanding on how the air bag works and possoibly a donner vehicle that will ihterchange.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


How do you take drivers airbag out on a 2006 saturn ion?

it is theoretically possible but for all practical reasons not really

When dealing with any part of the airbag system my recommendation is to take the vehicle to the dealership where a train technician can install the new airbag and reset the system. This way if you install the new airbag and the system is not reset. It may malfunction in the event of a collision or it may charge the new airbag and blowup when connected.

At the drivers safety submission.

Don't do that!It's a major mistake to do that!The airbag is a safety device.

Don't do that!It's a major mistake to do that!The airbag is a safety device.

Don't do that!It's a major mistake to do that!The airbag is a safety device.

Don't do that!It's a major mistake to do that!The airbag is a safety device.

The 2002 Acura airbag control module is located on the firewall in the engine compartment. The airbag control module will be on the drivers side of the firewall.

The 1997 Oldsmobile airbag module sensor can be found below the dashboard on the drivers side. The airbag module should be labeled as such.

The driver airbag is always located inside the steering wheel.Look at the steering wheel cover for the letters SRS or the word "AirBag".If the airbag does exist,you will see that written.

It has a drivers side airbag only.

Don't do that!The airbag is a safety device which can save the life of the passenger in case of an accident!However,as the Corvette is a 2-seat car,if you are talking about a child,I strongly recommend you to install an aftermarket Passenger Airbag ON-OFF switch.That is possible even for older car models.Contact a Chevrolet dealer.

The airbag light stays on when there is a malfunction in the system. The airbag computer will need scanned to know possible causes.

Under drivers seat,under carpet.

No , from what I've read the 1995 Ford Ranger has a drivers side airbag and the passenger side airbag was added in 1996

The airbag computer will command the airbag warning light to stay on when it detects a malfunction. You need to have the code read with a scan tool to know what the possible causes could be.The airbag computer will command the airbag warning light to stay on when it detects a malfunction. You need to have the code read with a scan tool to know what the possible causes could be.

A 1996 Ford Ranger could be equipped with a passenger side airbag ( SRS ) * so maybe yes and maybe no * All the 1996 Ford Ranger models have a drivers side airbag

I do not think so. I presume your light will not go out. The only airbag sensor is located in the airbag module (controller). Every other airbag connection is monitored for sort or open circuits My theory is the tester sat in the drivers seat during the test and twisted round in such a way to make the seat sensor or its wiring fail. You could check for an loose connector under the drivers seat. However to extinguish the light the faults will have to be cleared by an airbag scan tool.

You do not. This is illegal and very dangrous.

sounds like earth fault under drivers airbag, very common but will need to follow process to remove airbag.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.