0
Is it possible to remove a head without removing the distributor on a 1971 Chevy 350 v-8?
Wiki User
∙ 11y ago
Well if you were working on an old Ford engine you could slide the head out from under the intake with out removing it. But on a chevy you MUST remove the intake manifold to get the head off. Now that's means you would have to remove the distributor too be able to remove the intake. It can't be done CORRECTLY by leaving the intake on. SO NO.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Can you remove the front cylinder head from a 1995 Chevy Lumina 3.1 without removing the intake?
no it is not possible
How do you remove power steering pulley without removing power steering pump from your 1997 Buick Le Sabre?
It is not possible to remove the power steering pulley on a 1997 Buick Le Sabre without removing the power steering pump.
How do you remove the computer on a 1988 full size bronco?
It depends on what you mean by computer. The '88 bronco has an TFI control module mounted on the distributor. It is held on by 2 Phillips screws and should be relatively easy to take off without removing the distributor.
Is it possible to get to all the plugs without removing anything else on an Oldsmobile 88 1996?
It is but is easier if you remove the brace between the two strut towers
Can you remove a transmission on a 2001 Eclipse without removing the right Transaxle?
The car has only one transaxle, AKA transmission, then no, you cannot remove the tranny without removing the tranny. If you mean without removing CV Axle or drive axle or Axle shaft or CV shaft (same thing) then the answer is still no. You cannot remove the transaxle without removing the drive axle/CV shaft.
How do you remove the distributor on an EA falcon?
To remove the distributor on an EA Falcon, first remove the distributor cap. Use an extension bar to reach and remove the small lug that holds the distributor.
Do you have to remove the radiator before removing the fan clutch in a trailblazer?
yes you can remove the fan clutch without removing the rad. it is tight but it can be done. it is easier with the Rad removed
How do you remove the distributor rotor on a 1989 Isuzu amigo?
There are 3 screws holding the distributor cap on. After removing the cap, there is a small Phillips head set screw holding the rotor in place on the shaft portion of the rotor.
How do you replace the distributor modulator on a 1989 mustang 302 ho?
The TFI module sits on the front of the distributor. I was able to remove it without removing the distributor. Its a rectangular grey or black plastic module with a large electrical connector. Napa sells a special wrench for removing the screws. They are small and difficult to get to. I would recommend this tool as it helped me greatly. I think its called a Ford TFI Module wrench. Remove the large electrical connector and remove the two screws holding the module to the distributor. Apply a generous amount of thermal paste to the back of the new module. Make sure there is an even coating and no air pockets in the thermal grease. If this step is not done properly it will burn up the new module. Install the new module on the distributor and fasten screws. Install connector.
Is it possible to remove the cylinder head on a 2001 Chrysler PT cruiser 2.0 DOHC without removing crankshaft pulley as I am not changing the timing belt just installing refurbished head?
No.
How do you remove ignition from 1995 Toyota Paseo?
You need to specify which parts of the ignition system you intend to remove. You can remove ignition from your vehicle entirely by removing the ignition coil wire from the distributor but I don't think that's the answer your looking for.
How do you remove a distributor cap screw bolt rusted stuck without destroying distributor?
Most of the time it breaks off and you will need to drill it out and replace screew.
