0
Is the housing for the thermostat have 2 bolts n then should come off?
Wiki User
∙ 14y ago
yes, most times the last machanic used liquid sealer and is stuck to the housing, pry it off or hit with a rubber mallet
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the Location of the thermostat on a 1994 Nissan pickup?
Look where the upper and lower radiator hoses go after they come out of the radiator. There should be a housing on one of the two with 2 or 3 bolts holding it on. Remove the housing and the thermostat should be underneath.
How do you change the thermostat on a 2003 liberty sport 3.7L and where is it located?
The thermostat housing is where the lower radiator hose attaches to the engine. remove the hose and the housing (2 bolts) and the thermostat is in there (it may come out with the housing)
How do you replace thermostat in 1995 ford aerostar?
Where the top radiator hose goes to the engine there is a two-bolt housing that the hose is connected to, that is where the thermostat is . After the engine is cool, drain enough coolant from the radiator so when removing the two housing bolts you don't lose a lot of of it. After removing the 2 housing bolts You should find your thermostat setting in the intake manifold for the 4.0 and just behind the housing in the 3.0 just give it a little twist and it should come out then.
Where and how to change thermostat 98 mits mirage?
You first have to remove your air filter housing in order to get to your thermostat. Once you have done that you should be able to look down and it should be right beside and below the intake manifold you have two bolts one you can visibly see and the other directly across form but on the other side of the thermostat housing. Once you take of those two bolts the thermostat housing should come off. Then there is your thermostat. you may need to take a small hammer or something to hit with to take out the old thermostat with just in case it is hard to take off by hand and there you go you have cahnged your thermostat.
How do you replace the thermostat located on a Jeep Wrangler 4 cylinder?
First you have to take off the fan shroud and fan. From there you will see where the upper radiator hose connects to the thermostat housing. It should be held in by 2 bolts just take those out and the housing will come with it. Underneath that housing is your thermostat. That's how it is on a 98 jeep unless yours is after 2002 it should be the same
How do you replace thermostat housing on Chrysler 300 2.7liter?
The thermostat housing on a Chrysler 302.7 L engine can be removed by loosening the 3 housing bolts. Remove the water hose and the housing will come off. Reverse the process to replace with a new housing.
How do you replace the thermostat located on a 1998 Chevy Lumina 3.1L?
Follow the upper radiator hose down to the engine. It is attached to the thermostat housing . There will be two bolts attaching the housing to the engine. Remove these bolts, and with a little effort (prying), the housing will come off. There will probably be brackets, wires, or other items which will have to be removed in order to get to the bolts. Installation is just the reverse, and be careful you don't get the bolts too tight. Always remember how the thermostat is sitting, replacement should be put in same way as the old one.
How do you replace the thermostat on a 2003 Ford Escape?
The thermostat, in your 2003 Ford Escape, by removing the water hose and the 3 bolts from the thermostat housing. The thermostat will easily come out. Reverse the process to install the new thermostat.
Where is the location of the Rear Thermostat for 2003 silverado?
It does not have a rear thermostat. It does have one in the housing were the lower radiator hose hooks to the engine/ water pump. There are 2 bolts in that housing remove them and the thermostat housing will come off. Make sure engine is COLD you will need to drain engine coolant
Where is the thermostat located on a 1989 Buick Century?
there are 2 large black hoses that come off of your radiator. the one located higher on the radiator (upper radiator hose) goes from your radiator to the thermostat housing. the thermostat housing is a metal tube that is bolted to the engine. the thermostat is located inside of the housing and can be accessed by removing the bolts
How do you replace the thermostat on a 2010 Chevy Impala 3.5?
You can replace the thermostat on your 2010 Chevy Impala 3.5 by removing the water hose and the 3 bolts from the thermostat housing. The thermostat will come right out. Reverse the process to install the new thermostat.
Where is the thermostat located on a 1996 Cadillac eldorado?
It is NOT on the upper radiator hose, it is where the lower hose connects next to the air filter housing. You do not need to disconnect the hose, there are two 10mm bolts that come off and the thermostat is inside this housing.
