Want this question answered?
AnswerA reset switch is to start something totally over. If a water heater stops heating, you can use the reset switch to start it working all over and see if there is a further problem.In computer hardware, which is the category you listed this question in, there is no reset switch on most modern computes. There is a power on/off switch, and you can restart the computer. On some older computers there is a reset button on the motherboard.
If you are looking for a reset switch, Chrysler does not use those.
try to start it turn switch off and back on and leave the switch on for 10 mins. try to start again and turn the switch off and back on for another 10 mins.try to start again turn the switch off and back on for another 10 mins.this should reset the computer and it should start
In the event of a collision, the flow of the fuel stops to prevent fire. You have the press the fuel reset button in order to start the flow again. The switch is called a fuel pump inertia switch.
if the vehicle won't start.
Start by turning the thing off, and then switch the blasted thing on again.
Did you reconnect the batt.? The computer might need to be reset. Push it to start it once and things might go back to normal.
Turn the ignition switch to the auxiliary position. Do not start the engine. Leave the ignition switch in the auxiliary position for 30 seconds. This will reset your alarm system.
how to reset hornet alarm,, cause my car can't start..alarm still active,,
i there a switch on a saturn that would cause it not to start Yes the neutral safety switch.
Move start switch to position "2". Within the first 4 seconds after moving the start switch to position 2, press the reset button for the trip counter twice within one second. The display for the service request is activated for about 10 seconds. Within these 10 seconds, move the start switch into position "0". The service request continues to be displayed. Press the reset button for trip counter and keep it pressed. Move the start switch into position "2". Continue to hold the reset button for the trip counter pressed until the signal sounds and the new start distance appears in the display (it takes about 10 seconds).-GMA
Do the following steps: Move start switch to position "2". Within the first 4 seconds after moving the start switch to position 2, press the reset button for the trip counter twice within one second. The display for the service request is activated for about 10 seconds. Within these 10 seconds, move the start switch into position "0". The service request continues to be displayed. Press the reset button for trip counter and keep it pressed. Move the start switch into position "2". Continue to hold the reset button for the trip counter pressed until the signal sounds and the new start distance appears in the display (it takes about 10 seconds).