0
Is there a difference between the bell housing bolt patterns 350 small block Chevy and 1.6L G Geo?
Wiki User
∙ 14y ago
Yes, It is not even close. It will not work.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Are the chevy and buick TH400 bell housing bolt patterns the same?
No.
What is the Difference between the Chevy LS and the LT?
What is the difference between Chevy trairblazer LT and LS
What is the difference between Chevy Trail Blazer LT and LS?
What is the difference between Chevy trairblazer LT and LS
What is the difference between a Chevy and a Ford?
Chevy uses lock washers. ;-)
How can you tell the difference between a Chevy 350?
BETWEEN a CHEVY 350 AND WHAT? Ask A question that makes sense !
What is the difference between an intigrated bell housing and the non intigrated bell housing for a 5 speed manual transmission on the 1994 Chevy 4x4 diesel pick up?
An integrated bell housing means it is part of the transmission assembly and can't be removed from the transmission. A non integrated bell housing allows the end user to remove the housing from the transmission usually by unbolting it.
What is the difference between an S10 and a Chevy S10?
An S10 is the same as a Chevy S10.
Difference between Chevy k1500 and Chevy k1500hd?
The HD has a heavier suspension
What is the difference between 305 and 350?
Subtract 305 from 350 and that will give you the difference (or interval) between the two numbers:- the answer is 45. However, if you mean what is the difference between a Chevy 305 and a Chevy 350, then it is the difference between the engine bore (the cylinder) sizes. The 305 bore is 3.740 inches. And the 350 bore is 4.000 inches, giving the Chevy 350 20HP more then the Chevy 305.
What is the difference between a 1990 Chevy silverado and a 1994 Chevy Cheyenne?
most 88-98 Chevy pickups are basically the same. the only difference between yhe cheyenne and silverado is the trim.
How does a shim go on a starter for a 1992 Chevy Lumina?
between starter housing & block
Trying to re install exhaust manifold on a small block Chevy truckhaving hard time bolt holes off a bit?
Possible difference in bolt patterns between heads and manifold. There were two different patterns used, switching from early to late around 1976 or 1977.
