NO...but there is a fuel tank pressure switch that tell your fuel pump when it has the proper pressure to turn the pump off once pressure is achieved.
72 Liters, or 19 U.S. Gallons
It is at the back - look for the accelerator cable connection follow it thru and the adjusting screw is on the opposite side
Were are wires for Mitsubishi 3000gt oil pressure switch
If your Diamante is the Dohc 6 cyl. motor in it then you have to remove the entire intake manifold to replace the back 3 plugs I did it in about 4 hours with not many tools and I am a female. So it can be done.
The 1995 Mitsubishi flasher relay switch and the brake light relay switch can be found beneath the dashboard. Both switches will be on the drivers side of the dashboard, near the brake pedal.
Ignition power control is located on the intake driver side next to intake motor control looks like small module black color. This is for 95 diamante with 3.0 SOHC engine.
NO, they are programmed differently.
its in the midle of the head under the powerstering pump you have to remove the timing covers if you are going to change it i would recomend the you changethe the timing chain
No - not unless you are running the A/C. One fan is for the engine and one is for the A/C. Each has its own temp. sensor.
I'm not positive but, i don't think the '95 galant or other yrs. have a "pump relay switch". they do have a pressure regulator and a relief valve. i would check your local dodge or Mitsubishi dealer and ask them.
It is quite easy to find. Stand up in front of the car. Either Soch or Doch engine, 3.0 L, it is located in the right-end, almost-top of front engine, nearest to radiator.
how to set the timing marks on a 1995 Mitsubishi Montero