Short in the wiring or the lamp holder for the tail light is corroded.
Change the fuse dummy
Where is the fuse box for a dodge sebring
There is no single fuse. The alarm is disarmed by unlocking the doors with the key or the remote.
When you remove the fuse box cover, look on the inside of the cover. The fuse identification is marked on the inside of the cover with the fuse locations.
It is very common for the starter to be the cause of that fuse blowing.
It is fuse #8 (20 A) (upper right-corner) located in the fuse box under the hood
Pulling a fuse will not clear codes on this vehicle. A scan tool is required to clear codes.
My seat heater stopped working. Is there a fuse for this? I can not find anything in my owners manual about the seat heater.
in fuse box under the hood
It is under the dash on the driver side. It is on the backside of the dash fuse panel.
They are two fuse boxes-one is on the drivers side near the back and the other is under the hood-you will see it when you raise the hood-right side.
Number 8, I think its the second 20amp fuse from nearest the driver seat side.
Check the fuse panel on passengers side in the door well
The main fuse box can be found in the engine compartment. The fuse box will be near the firewall on the drivers side.
The 2004 Chrysler Sebring starter fuse can be found in the fuse box. The location of the fuse can be found on the inside cover of the fuse box.
Open the drivers door, remove panel on left side of dash. This panel is covered when the door in closed.
It is the IOD fuse. It does not disconnect all items, but it does stop most parasitic draws.
There isn't a single fuse that will disable the alarm. You need to have the system diagnosed to find the cause of the alarm setting off. The dealer's scan tool may be required.
The fuse box layout, for your 2006 Chrysler Sebring, can be found on the inside cover of the fuse box. The fuse box is located in the engine compartment.
Possibly a bad brake light switch, or bad connection.
Take out the horn relay switch in an emergency. Without the alarm sounding off you can actually start to think...um...
The bcm is attached to the fuse box. You will have to remove the dash by taking out the screws around the radio and on the left side of the dash. You'll have to remove the dash silencer (above the driver's legs) as well. Unplug everything from the fuse box, then remove the three screws holding the fuse box in place. Pull the fuse box straight down to remove it. Unplug the bcm from the fuse box and remove the screws holding them together. Now you've got your part number and can look for a new bcm. (I had a hard time figuring out how to do this when the gauges in my '99 Sebring convertible quit working. It's pretty easy to remove and saves a lot of money when you don't have to take your car to a dealer. Good luck!)
The 2004 Chrysler Sebring fuse box is located in the engine compartment. The fuse box will be on the drivers side behind the battery box.
According to my Chilton repair manual: Fuse # 1 - 15 amp - for stop lamps/four-way flash/speed control inhibit Fuse # 11 - 15 amp - for park lamps / license lamps Fuse # 13 - 15 amp - for turn lamps/ back up lamps