Yes, you will need an analog multi meter (the one with a needle) I bought one from wal mart for about $8. Underneath the driver side dash is a fuze box, right next to it should be a white module that's open and has 12 pins sticking out of it. Connect the red lead to the one on the top left #1 and the black one on the bottom right #12--watch the meter needle--it will move slow (sweeps) that is representative of a number, then it will stop and then start to sweep fast--count all of the sweeps-slow and fast. You need a book to tell you what the codes mean. There's a website (316 garage) there is a ton of info on there.
Turn key on- off-on-off-on and count the long flash and the short flash. Looong-short-short = 12
Yes it will.
Nope. The engine computer controls everything from spark timing to fuel/air mixture. There's no way you'll get it to run without it.
I'm certainly NOT a mechanic but .... since the trouble codes are stored in the vehicle's on-board computer I doubt that there IS any way to retrieve them without a device and a program that can "read" the car's computer.
They can be mixed.
Although the 93 Dodge Stealth basic engine mechanicals are the same as one for a Montero, you would probably have to use different engine mounts and there may be a problem with how the engine mounts to the transmission. Then theres the possible problem of the engine computer for the Montero not working with the donor engine and the wiring harnesses not having the same plugs as the Stealth.
what procedure??
Both a 1990 Nissan 240sx and a Dodge Stealth are excellent sports cars, neither is better than the other. A Nissan 240sx uses a 140 horsepower engine and a Dodge Stealth uses a 164 horsepower engine.
With a scan tool
The 1991 Dodge Stealth fuel pump cutoff relay switch is located on the firewall in the engine compartment. You will find the relay switch on the drivers side of the engine compartment.
Connect an OBD2 scan tool which will retrieve the codes set by the ECU. If you mean how to check to see if the light is working just turn the key on without starting the engine. The check engine light will illuminate.
yes it will