Headlights Tail and Brake Lights
Chevy Tahoe
Dodge Caravan
Ford F-150

Is there a relay switch between the backup lights and the transmission neutral-safety-backup switch on a 1992 Dodge Caravan?

119120121

Top Answer
User Avatar
Wiki User
Answered
2006-05-01 03:44:31
2006-05-01 03:44:31

it is located under hood in relay and fuse holder. right by driver front fender

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


its on the front of the transmission, near the trans pan

The backup sensor is inside the transmission.

There is a backup light switch on the transmission.

replae backup light switch on transmission

The switch for the backup light switch for an automatic transmission is located on the transmission where the shifting cable enters the transmission (The side of the transmission closest to the radiator),how about for the manual trans mission models?

If the bulbs are the cause, remove the tail light assemblies and replace the bulbs; if they still don't work, replace the neutral safety switch, located on the front of the transmission.

It is inside the transmision, it is called the range sensor.

You would have to literally run a wire from the battery through a fuse and then to a toggle switch and then on to the backup lights, this will only function when the switch is on and will have nothing to do with the transmission being in reverse. This is essentially the same as putting a toggle switch across the transmission mounted switch (assuming the transmission switch is not shorted).

The backup switch is on top of the transmission directly below the battery. @ wires to it

On the side of the transmission has 2 wires running to it

shifter cable, low transmission fluid or faulty transmission.

Standard or automatic transmission, they both are mounted to the transmission.

If you have an automatic transmission it is on top of he steering column just before it goes through the firewall. If you have a manual transmission it is on the transmission.

There is a switch in the transmission (manual) and I believe also automatic that triggers your backup lights when you move (change gears) into reverse. If the switch (in the transmission) does not touch (trigger) the backup light switch; or if the switch is not working; you will not have any reverse lights. Also , if you have had any changes in your transmission due to lifting the body, or changing the original transmission; the lever that triggers the switch may not be able to come in contact with the backup light switch in the transmission. If you have this switch replaced by a garage it may run around $160 for the switch and another $100 to $200 for labor. If the transmission does not trigger the backup light switch in the first place ,due to changes in the transmission, or a body lift; then changing the switch will not make any difference; the backup lights still will not work.

In Microsoft Windows an incremental backup backs up everything that has changed since the last backup. A differential backup is a cumulative backup of all changes since the last complete or full backup.

Eatx stands for electronic automatic transmission controller the eatx relay provides power for the controller and the backup eatx relay is for the backup lights.

It's on the nose of the transmission

They are usually located down on the side of the transmission.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.