Not sure what you mean by sequence. The harness does have a proper routing location and it must be plugged into the proper locations.
Wiring runs all over the vehicle.
Yes and no. As long as the motor is the same, the harness should be the same.
It really depends on which wiring harness. If you are asking about the whole cars wiring I would seriously take it to a shop. Other harnesses may be easy, like the radio harness, and door switch harnesses are the easy ones.
simply get a different wiring harness from the junk yard
30x 10.5
maybe not free but cheap at the junk yard
Yes, but you will also need the wiring harness and ecm.
It is a wire loom that powers the buttons/switches for the power seat!
Depending on type of switch- either unscrew or just pry out
you have to remove the back driver trim in the back of the jeep..........you will find a green plug, the aftermarket wiring will plug into that.......................good luck
A 318 (5.2L V8) will fit with a different trans, computer and wiring harness.
Fix the wiring harness between the body and the door, then in 10 months do the other side!!