open bleed valve on top of distribution pump, crank engine till fuel squirts from valve, tighten valve, turn over couple times. Add heat and fire up.
A valve to bleed out air manually
By using the bleeder valve by the boiler
This vehicle does not have a bleed valve, it is not needed.
The Villager engine does not have a coolant bleed valve.
It doesn't have a bleed valve for the power steering.
You can't bleed it any other way, you have to bleed it through the bleeder valve to get all the air out.
To bleed the cooling system on a 1996 Olds Cutlass, locate the bleed valve, which is on the front of the engine above the water pump. After making sure the cooling system is not under pressure, open the valve by turning it counterclockwise. Fill the radiator with coolant until no air comes out the bleed valve, and a stream of coolant begins to flow from there instead. Tighten the valve and close the system to finish the job.
its a valve to let the air out of the system
The bleed valve is located on the drivers side of the bell housing.
Bleed valve is located on top of thermostat housing.
Use carb cleaner and a wire brush.