There is definitely some power loss during transmission from satellites to Earth. The exact amount isn't really known since such a system doesn't exist currently. However, I would actually expect it to be somewhat low due to the direct nature of the signal. I would imagine more loss occurs during conversion into microwaves and back into electricity before and after transmission. To learn more about how solar power satellites work visit the related link.
Most solar panels would last about 25 years Most solar panels would last about 25 years ---------------------------------------------------------------- from www.solarcells101.com Most solar panels are rated 25 years But its hard to say because most of the first solar panels in the 1980s are still putting out power they will have a power loss over time but free power for this long is very cool David www.solarcells101.com
it's either 40% or 60%
It depends what you are exposed to: Radiation can cause caner and imune diases, Microgravity causes bone loss, solar flares cause radiation
A solar box cooks because the interior of the box is heated by the energy of the sun. Sunlight, both direct and reflected, enters the solar box through the glass or plastic top. It turns to heat energy when it is absorbed by the dark absorber plate and cooking pots. This heat input causes the temperature inside of the solar box cooker to rise until the heat loss of the cooker is equal to the solar heat gain. Temperatures sufficient for cooking food and pasteurizing water are easily achieved.
Solar batteries should be stored in a cool dry place. This also extends the life of the battery. Batteries can also be stored in plastic battery storage containers. Keep in mind the storage area should be kept at or above 40 degrees to avoid capacity loss.
The term, 'power loss', describes the rate of energy losses caused by the load current in the transmission lines
Reactance certainly causes loss in a transmission system, but I^2R or resistance losses are greater.
Power loss.
Could be the transmission, tune up, fuel filter or a loss of compression.
You wouldn't have any power in your home,calculator,etc.
the loss of sun
Actually surge impedance is present in a transmission line due to the capacitance of transmission line. Now this capacitor attends the reactive power of the transmission line to energise its magnetic flux. now due to the flux the impedance will increase and the power is reactive too. due to the impedance loss is more.
The reason electricity is trsnsmitted at very high voltage is to reduce energy loss. As Power = V x I and heat loss = I2 R. Thus if I the current is low the energy lost in the transmission cables will be minimal. The reason electricity is trsnsmitted at very high voltage is to reduce energy loss. As Power = V x I and heat loss = I2 R. Thus if I the current is low the energy lost in the transmission cables will be minimal.
Voltage is stepped up during transmission to reduce the power loss during transmission due to resistance. Power is a product of Voltage*Current, and losses due to resistance are directly proportional to the square of the current. Now when we increase the voltage , keeping the power constant, the subsequent current reduces.. thus in turn reducing the transmission losses.
Yes, solar power plants are better than wind power plants. The reason is that wind power plants convert wind into electricity, but if there is no wind, wind power plants won't be able to do their job. Solar Power Plants use solar energy from our entire solar system. There is infinite solar energy in the solar system, so solar solar power plants are better. Solar and wind do not produce any real power in terms of our needs. Solar is the worst of the two by a small margin. Typical payback, in terms of energy used to create and maintain a solar panel is longer then the projected life of a panel. Winds worst issue is the needed fossil fuel plants running in the background. This power is completely wasted unless the wind stops or slows below the running speed of the turbine. Wind also stops generating power at speeds above 32 mph. The fossil fuel plant again will make up this loss. The better alternative is hydro then either of these that provide little or no power.
there are some distortion in transmission line : copper loss,dielectric loss,skin effect
Line current = 10MW / 500kV = 20A Assuming the 1000 ohms is the resistance of the entire transmission line, end to end. Power loss = line current ^ 2 * line resistance = 20A ^ 2 * 1000 ohms = 400 KW