0
Is there any way to repair the mesh on the V- grids of Doughboy Sequel I Plus pool filter?
Wiki User
∙ 11y ago
I have success using marine epoxy. The material should be dry, allow to completely dry before installing. Try to extend the epoxy at least 1/4"or more beyond the damaged area.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you replace de filter grids?
Fiberglass Repair Webbing ( used for drywall taping) & 5 minute epoxy !..waterproof.
Why is DE chemical going through into the filter and causing powder on the floor of your pool?
Worn or damaged filter grids. Replace all grids with holes and recharge filter.
You see particles floating in your pool water and it is cloudy - why?
Bad filter elements for a D.E. filter. Remove, clean filter grids and replace damaged grids. Reassemble and recharge with correct amount of D. E. Ken
Why is your filter full of de on outer filter grids?
Because it filters from the outside in. The DE is supposed to coat the outside. Hatawa
Why your filter seems to be returning fine brown debris back into pool and settling on the bottom.?
Your D. E. filter grids are damaged. How old is the filter?
What causes pool to be cloudy you have de filter has been cleaned and seems everytime the pump starts de shoots into the pool?
The filter needs to be dismantled to find the damaged elements and replace them. While the filter is down have all the grids inspected and cleaned to determine if more are damaged. Depending upon filter brand there are 8 grids.
How do you install grids for a pentair DE pool filter?
View the related link below for information.
Why does d e go right though the filter into the pool?
Because there is probably a tear in one of your grids inside of the filter that needs fixed.
What is a vacuum tube that contains a grid called?
one grid - triodetwo grids - tetrodethree grids - pentodefour grids - hexodefive grids - heptode, pentagrid convertersix grids - octodeseven grids - nonodeetc.
What is de for a pool?
DE, also called Diatomaceous Earth, are the bones of tiny anamils and algae that lived millions of year ago. It's used to coat the grids of DE filters. The dirt is trapped in the DE on the grids and is back-washed out, similar to a sand filter. Then fresh DE is put in the skimmer and re-coats the grids. About once per month you should take your DE filter apart and clean the grids, then re-coat them with fresh DE. DE filters are a bit more expensive but if you have to have the best water, DE is the way to go.
Why does the DE shoot back into the pool every time you re-charge it?
You have damaged grids inside the filter. Remove and replace. k
Why would the pressure on a Nautilus FNS filter get higher when the filter starts after being idle?
What was your clean starting pressure? When was the last time that you backwashed the filter? When was the last time that you broke the filter down and cleaned the grids in the proper manner? Sounds like your filter is getting dirty. k
