0
Is there easy way to remove bank 1 catalytic converter on 2007 pilot?
Syllinx
I meant to replace it. Sorry. At work so had to type fast lol. I was told to remove the drive shaft but the Chilton manual says to just remove cross member then unbolt converter.
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
Does a 2007 Dodge Ram with 5.9 Cummins have a catalytic converter?
Yes. From the factory it has a catalytic converter.
Is it legal to remove the catalytic converter from a diesel pickup in Michigan manufactured before 2007?
u need to check your exhaust system i have never yet seen any diesel that has a catalytic converter installed
Does a 2007 dodge ram 3500 6.7L have a catalytic converter?
Yes
Where can you buy a used or rebuilt catalytic converter?
You can not. There are no rebuilt cats and it is not legal to sell a used one.
Where is the catalytic converter on a 2006 hyundai elantra located?
Hyundai Elantra Catalytic Converter neutralizes the poisonous substances. They are available for the following Hyundai Elantra years: 2007, 2006, 2005, 2004.
Where is the rear oxygen sensor on a 2007 Ford 500?
It is threaded into the exhaust system after the catalytic converter.
Where are the oxygen sensors on a 2007 Dodge Sprinter?
They are in the exhaust pipe, on either side of the catalytic converter.
Where is the o2 sensor on a 2007 dodge caliber?
There are two, one on each side of the catalytic converter on the back of the engine.
Where is the bank 1 o2 sensor on a 2007 gt mustang?
Bank 1 is the passenger side of the engine in your Ford Mustang Sensor 1 is in the exhaust BEFORE the catalytic converter ( upstream ) Sensor 2 is in the exhaust AFTER the catalytic converter ( downstream )
What can cause a rattling sound on a 2007 hummer h3?
Check the heat shield on the catalytic converter Check exhaust hangers
How do you remove the turbo on a 2007 dodge sprinter van?
1.Disconnect negative battery cable.2.Remove the engine trim cover.3.Remove air intake tube (air cleaner to turbo) (1).4.Remove engine cover front bracket (2).5.Remove air tube (turbo to cooler) (3).6.Remove the turbo heat shield (4). Remove the elbow to converter exhaust clamp (1). 8.Remove the turbo front bracket retaining bolts (1).9.Raise vehicle, remove front splash shield.10.Drain cooling system.11.Disconnect the downstream catalytic converter at the extension pipe.12.Disconnect the extension pipe to muffler.13.Disconnect O2 sensor wire connector.14.Reposition extension pipe and catalytic converter.15.Lower vehicle and disconnect catalytic converter to downstream catalytic converter clamp.16.Remove upstream catalytic converter.17.Disconnect transmission fill tube and trim cover bracket and set aside. 18.Disconnect exhaust elbow at turbo (2).19.Disconnect EGR tube at manifold to left cylinder head (3).20.Remove left and right exhaust manifold retaining bolts and gaskets (4). 21.Remove front turbo retaining bolts (1).22.Remove turbo mount retaining bolts.23.Remove turbo.
How many o2 sensors on a 2007 Gmc Yukon and where are they located?
there are 4 O2 sensors on a 2007 Yukon. 2 on each side. upper bank is on the down tube of the exhaust prior to the catalytic converter, lower bank is after the catalytic converters
