0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What do i lubricate pool strainer o-ring with?
Get an O ring lubricant this is available in plumbers supply stores. pool shops automotive spares dealers. I find a bit of Vaseline or other petroleum jelly work quite well also.
Why would the sand filter be leaking where the lid attaches to the tank if you have a new and lubed o ring?
i believe you trouble is ..........sand...you have to get every little piece of sand off the o-ring and the groove...good luck Also make sure you are using approved Lube. Vaseline can cause a ring to loose its form and cause leaks. There is also the possibility that the lid is warped from age.
Why would the sand filter be leaking where the lid attaches to the tank if you have a new and lubed o-ring?
i believe you trouble is ..........sand...you have to get every little piece of sand off the o-ring and the groove...good luck Also make sure you are using approved Lube. Vaseline can cause a ring to loose its form and cause leaks. There is also the possibility that the lid is warped from age.
How do you lubricat o rings?
You can lubricate O-rings by hand. Just make sure you use the correct type of rubber lubricant that is compatible with the O-ring material and what you are trying to seal. Michael Chou Mechanical Engineer http://mykin.com
Do you need gasket sealer for the o ring gasket on the oil cooler on a 350 Chevy engine?
NO you do not. That is what the o-ring is for. If you use sealer it will wind up in the oil and that is Not good.
When was Ring a Ring o' Roses created?
Ring a Ring o' Roses was created in 1881.
What does O in O-ring stands for cause ring already known as a round part?
'O' refers not to the shape of the ring but to the ring's cross-section.
When you put in a erring it hurts to o through the hole what do you do to make it better?
vaseline
Where does the o ring belong?
Depends on what type of o-ring it is.
On a 1998 blazer wheel bearing assembly where exactly does the large o-ring go?
2000 BLAZER FRONT WHEEL HUB INSTALLATION, WHERE DOES THE LARGE O-RING GO? You can see the outer race of the wheel bearing is stepped. The large o-ring goes over the first step and buts up against the second. The o-ring may be slightly larger than the smaller diameter area on the outer race, fit a little loose, and be a little larger on outside diameter than the larger part of the bearing. The hub needs to be put in evenly. Tighten each bolt a flat at a time if you need to. The o-ring should lubed a little (I used Vaseline). As you tighten the bolts continue to check the o-ring to make sure one part isn't popping out the front or back. The o-ring should rest against the step in the knuckle which corresponds to the bearing. This is not a gasket for the dust shield.
Who manufacturers high quality seal o rings?
Integy Seal O-Ring are very good. Hagen is okay though.
What nursery rhyme had bubonic plague?
Ring o' ring o' roses
