0
Just had intake gasket fixed then turned around and had to get the heater core fixed now it is not blowing out hot air out of the heater why?
Wiki User
∙ 16y ago
Check the temperature gauge. If it is running cold, replace the thermostat.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Where could engine coolant be leaking from on rear topside of engine on a 1998 350vortec it pours coolant out but can't see where from?
It is common for the intake manifold gasket to leak antifreeze from the corners of the intake. Need to replace intake gasket. Be sure to look closely at the intake were the gasket seals against it for pitts in the intake. There is a heater hose that goes into the intake on right rear corner in the back, but uo on top of intake. check closely. It is common for the intake manifold gasket to leak antifreeze from the corners of the intake. Need to replace intake gasket. Be sure to look closely at the intake were the gasket seals against it for pitts in the intake. There is a heater hose that goes into the intake on right rear corner in the back, but uo on top of intake. check closely. It is common for the intake manifold gasket to leak antifreeze from the corners of the intake. Need to replace intake gasket. Be sure to look closely at the intake were the gasket seals against it for pitts in the intake. There is a heater hose that goes into the intake on right rear corner in the back, but uo on top of intake. check closely. It is common for the intake manifold gasket to leak antifreeze from the corners of the intake. Need to replace intake gasket. Be sure to look closely at the intake were the gasket seals against it for pitts in the intake. There is a heater hose that goes into the intake on right rear corner in the back, but uo on top of intake. check closely. It is common for the intake manifold gasket to leak antifreeze from the corners of the intake. Need to replace intake gasket. Be sure to look closely at the intake were the gasket seals against it for pitts in the intake. There is a heater hose that goes into the intake on right rear corner in the back, but uo on top of intake. check closely.
Your 2000 blazer started blowing out air that was not warm when the heater was on. It started working after about 15 minutes.?
I am having the same problem.. I have already had to replace the intake manifold gasket cause it was leaking, still no heat. We will be flushing out the heater core to see if that's the problem. I may have to replace the heater core, we will see.
If your 1999 Ford Crown Victoria has an antifreeze leak at the rear of the engine what could it be?
check your heater hoses one connects to the intake on rear passanger side of the motor it is likely the intake cracked there is a recall on this issue if the intake has been replaced with factory intake it is possible that the intake gasket is leaking check the bolts to be tourqed to specs if gasket is leaking replace gasket Crown Victoria Plastic Intake Manifold Heater Leak Fix When the stupidly designed intake manifold cracks where the heater pipe sticks into the plastic here's how to fix it. You will notice the plastic around the heater pipe is connected to some plastic to the front of the car from it. Take a hacksaw blade and cut about a 1/2" groove in that plastic - just enough to get a hose clamp around the plastic circle that holds the pipe. Tighten the clamp and voila! No more leak.
What will cause coolant to get in oil head gasket or intake gasket?
The Intake gasket is leaking, NOT THE HEAD GASKET. Replace the intake gasket
What is the labor time to replace intake manifold gasket on a 2001 intake manifold gasket?
around 6-7 hours according to AllData
You own a Chevy 305 it is leaking water from in between valve covers under carb near distrubutor is this a head gasket?
NO NO, That would be a intake gasket leaking, not a head gasket. You also should check where the heater hose hooks up on the intake, it may be leaking.
4.3 vortex taking in water around the intake is this common with these engines or is my block probably cracked i have a lot of water in oil?
had the same problem. my son is a ASE master rated gm tech, he said the 4.3's are bad about blowing the intake gasket. i just did a 96 blazer, water in the oil . pulled the intake and a blown gasket was the problem. hope this helped, BJ
What is wrong when a 1995 cutlass and recently it started to have high temp and water in the oil heater not getting warm what could be wrong and is it too much to fix?
Blown intake manifold gasket or blown head gasket, figure on $600 to $650 to get intake gasket fixed and if a head gasket your looking at least $1,000.
What is a intake gasket?
The intake gasket is the gasket that conncects from your air filter into your intake manifold
If the intake manifold gasket leaks on A 1994 ford explorer does the heater work?
yes it will still work if you get cold air your heater core could be pluged or the coolant is low
How do you fix intake gasket on 2000 lasabre?
The only fix for a bad intake gasket is to remove the intake manifold and replace the gasket.
What is the cause of the intake manifold head gasket blowing on an 1999' Chevy Suburban?
That is a common problem with the Vortec engines, First place the gasket is not made of much as you can see. Antifreeze eats the gasket up over time. The ORANGE antifreeze is BAD. If the Intake was OVER TORQUED that will cause it to leak/ Go bad too.
