answersLogoWhite

0


Best Answer

Try setting timing to "TDC" No. 1 cylinder on compression stroke Make sure firing order is correct Should start at this point and then set timing from there

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Just rebuilt a 350 small block engine cranks but won't start gas shoots up from carb and smoke does as well engine backfired violently through carburetor how do you get it timed right so it fires?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where can you buy a Huayi P15D carburetor?

You can buy a Huayi P15D carburetor at Fuding Jekco Carburetor, Ltd. and through eBay. See the related link for further information.


Where carburetor air out?

I believe it's through the muffler


What is a Water Choke Carburetor?

It is a carburetor where the engine coolant is routed through the choke system of the carburetor. When the coolant is cold the choke will close. As the engine coolant heats up it opens the choke.


Where does the fuel to a carburetor float bowl enter through?

The needle and seat.


Why is there oil around your harleys carburetor?

the crankcase vents through the breather system.


How fuel and air mix in car engine?

Either through a carburetor or by a fuel injector.


Why does an engine backfire through the carburetor?

Incorrect timing or plug wires connected incorrectly.


Why does my Polaris 500 pop through carb wont start?

A carburetor will not start when it does not yet enough fuel. A carburetor will not start if it gets too much. Fuel and not enough air.


Where can you buy a rebuilt differential for an 2003 Explorer?

You can usually buy rebuilt parts from a salvage yard or a repair shop associated with a salvage yard. You can also buy these through the internet.


Looking for a carburetor for a Crasftsman Edger Mod 536 -871200?

A carburetor for the Craftsman Edger model 536-871200 can be ordered through any Sears store. These stores do not sell the parts inside the store, but can order the correct part through the catalog.Ê


Carburetor diagram 1983 ford econoline e-150?

The carburetor diagram for a 1983 E-150 can be found in the service manual. The manual can be purchased through most auto parts.


What is is jet for in carburetor?

the jets are inside the carburetor. They look like brass pipes, they can be unscrewed. The jets have to be clean (the hole has to run all the way through the jet) in order for the engine to run.