0
Add your answer:
Earn +20 pts
What would you cross reference with a John Deere belt GX 20006?
Gates Belt #6690BR
What would you cross reference john deere belt m122075 with?
A 37" x 1/2" belt
What would Cross reference sears 174883 mower belt to any other belt to?
It is a standard 5/8" x 97" belt.
Cross reference for Perkins fan belt 2614B562?
Gates 6487MC . Generic # is 13AV1425 .
What is the drive belt cross reference for Comet 20694?
That is what American Sportworks numbers the Comet belt. The Comet Industries belt is available in the related link.
What is a cross reference number for a mitsuboshi belt part number RECMF-6530?
Gates 9540
How do you adjust the drive belt on a 610 kawasaki mule?
Take it to your nearest certified Kawasaki dealer...
What would Cross reference John Deere Belt M123281 to any other belt?
Belt# M123281 crosses over to Oregon part #75-297 and the dimensions are 1/2"x142-3/4"
How do you tighten belt on kawasaki brute force?
how do u tighten belt on brute force 750?
Installing drive belt for 1999 Kawasaki Prairie 400 4X4?
To install drive belt on a 1999 Kawasaki Prairie 400 4x4, access the engine area and remove the cover that holds the clutch. Remove the drive belt around the clutch at the right side of the engine. Replace with new.
Where is the VIN on a Kawasaki Prairie 650'?
I believe its on the right side of the bike. Just below the belt cover.
How do you replace the drive belt on a kawasaki mule 2510?
You need a special tool from Kawasaki to hold the drive pulley. The Kawasaki part number for the tool is 57001-1520. After you remove the convertor cover. You remove the drive pulley by bolting the tool on the three upper bolts then take off the drive pulley nut (left hand threads). Once the pulley is off take the belt off the driven pulley then you can reinstall the new belt. You also have to check the belt deflection. Put a straight edge from the belt on the drive pulley to the belt on the driven pulley. Using a ruller push down on the belt. The deflection should be no more than 1". If it is I would take the ATV to a Kawasaki dealer. They will need to add or subtract springs and shims from the drive pulley. If the old belt has never been change you might be OK by just replacing it. I have not tried to take the drive pulley off without using the special tool from kawasaki. The best thing you can do is go to RepairManuals.com and look up a KVF650 2003, you can buy the OEM repair manual for $60.00 plus about $6.00 shipping. It has saved me a lot of money.
