0
Add your answer:
Earn +20 pts
Why wont the temperature gague work in my 1996 Chevy silverado?
Bad temperature sending unit? Bad gauge?
Diagram of a transmission 1996 Geo Metro?
transmission goes into gear but wont hardly move
Kia sportage air conditioner and windows wont work?
check your fuses for both problems.
Why wont rear windows open 2001 Kia Sportage?
The child safety window lock-out switch is on.
Why after Changing the timing belt on a 2002 kia sportage and is still wont start?
we checked the fuel pump and its good???
After vehicle repair The fuel gauge on my 98 intrigue has gone around and is pegged opposite full mark and wont move how do you reset it?
What was the repair? Sounds like they did more harm than good. Could be disconnected. If not, there may be a blown fuse or (worse) a blown resistor in the gauge.
Why does a gas gauge show only half full even though the tank is full and the gauge is still operating?
There is a sending unit laocated at the fuel pump that sends info to the gas gauge. This can malfunction with no reason at all. I am betting that this is the reason since your gauge still moves. If the gauge is bad usually it wont move at all and is not a common thing now a days anyway. The sending unit is more common. Hope this helps.
1996 dodge intrepid wont start?
If the 1996 Dodge Intrepid will not start, there might be an issue with the battery or the starter. This could also be a problem with the solenoid or the fuel gauge or fuel pump. The problem and the fix will vary depending on whether the car is completely dead or is cranking when the ignition is turned.
Eb falcon 1993 fuel gauge shows full then drops to empty and wont work?
check your ground wire to the gauge
94 Sunbird temperature gauge will not work?
If it gets to hot the thermostat wont work. you need to repace it and the gauge will work again.
Why wont 1996 ford explorer start you can crank it but it wont start?
do you have gas in the tank
Why my Water temperature gauge doesn't work on 95 explorer?
only 3 reasons a temp gauge wont work the temp sender is bad the gauge is bad or the wire from temp sender to gauge is broken
