answersLogoWhite

0


Best Answer

its on the driverside of radiator. Near the bottom. just a plastic pipcock.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Location of coolant bleeder screws 2003 dodge 5.7?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the location of the coolant temperature sensor-Dodge 360?

beside the thermostat housing


Where is the coolant temperature sensor on 1999 dodge neon sohc?

The coolant temp sensor screws into the side of the engine. It is located just below the connectors for the heater hoses.


Does a 2001 dodge ram van have a radiator bleeder valve?

No it does not.


Location of the coolant temperature sensor of a 1999 Dodge Grand Caravan?

its on the left side by the belts right above the thermostat


Where is 1998 Dodge Ram 2500 Cummins diesel coolant drain plug location?

Lower driver side of the radiator.


Where is the bleeder valve forthe brakes of a dodge Dakota?

located on each brake caliper/wheel cylinder for drum brakes. have an assistant pump brake pedal several times then hold down. open bleeder valve. repeat on each wheel until only fluid comes out. top off master cylinder as required. I suggest using line wrench on bleeder screws.


Does a 1995 dodge ram truck have bleeder valve in the cooling system?

No, it does not.


What type of coolant do you use in a 1999 dodge stratus?

coolant type 1999 dodge stratus?


Where is the location of the idle air control valve on a 1993 Dodge Dakota?

Its on the back of the carb, two screws and its out, real simple job


Where is the radiator bleeder valve on a 1998 dodge ram 1500?

It doesn't have one.


Where do you put engine coolant for Dodge Caravan?

in the coolant resivor


How do you change 2004 Intrepid coolant air bleeder?

This part must be defective on this year intrepid because I've this part replaced twice this year and this last time it actually blew entirely apart leaving only the bleeder screw with a small piece of plastic. My advice is to have dodge repair it because it will most likely break again