answersLogoWhite

0


Best Answer

Most likely problem on those vans is still the Power Steering pump.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: MY 1998 ford windstar van has a gear-gear pump noise starting at slow speed what can cause the noise it does not change if you turn the steering wheel or put the car in neutral while rolling?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why does your ford windstar only drive in neutral?

If a Ford Windstar only drives in neutral, it may be due to a blown fuse. It will be best to check the neutral safety switch or brake pedal switch.


How to unlock steering wheel on ford windstar 2002 model. Car starts but will not go in to drive or unlock steering wheel. Which fuse goes to the steering wheel lock?

Check the fuse for the brake lights, it's the same circuit. I believe you can also turn the key to the first position before the ignition lights up and without starting the engine depress brake pedal, take it out of park into neutral, then start the vehicle.


What is a trs sensor on a 1998 ford Windstar?

Trs is transmisson range sensor-(neutral safty switch)


Can a jeep wrangler 4 wheel drive automatic transmission be towed behind an rv?

Yes, transmission in park, transfer case in neutral. With the steering wheel unlocked.Yes, transmission in park, transfer case in neutral. With the steering wheel unlocked.


What is code P0715 on 95 windstar gl 3.8 fuel injection?

po715 is the code for the neutral safety switch.


Where is the neutral safety switch on 1973 eldorado?

on the steering co[um shaft


What is the neutral switch?

neutral safety switch will stop vehicle from starting in all gears except park and neutral.


Can I bypass the neutral safety switch located on the steering column of a 1972 Cutlass Supreme?

Yes you could but it has a neutral safety switch for a reason.


Where is the location of neutral switch on 1998 E150?

On my 1990 Ford E150 4.9L I6, the neutral switch is below the steering wheel, half way down the steering column, on the top side of the steering column. Just keep unscrewing things until you can access the switch, then remove the switch.


Where is neutral safety switch located on 2000 ford contour?

maybe in the steering column


Where is neutral switch on 1972 Monte Carlo?

On top of lower portion of steering column.


How can you bypass a neutral safety switch on a 1996 Ford Windstar?

You do not bypass a neutral safety switch.It is critical to the operation of the vehicle.Spend the $25 to buy a new one - then follow the instructions in the "Related Questions" below to replace it.