The condition in which a feature contains the maximum amount of material within stated limits. This condition is called as Maximum material condition (MMC)
e.g.: Minimum hole diameter, maximum shaft diameter.
Manganese
The metal loses its electrons and trannsfers them to the non-metal to form an ioinic bond.
Coils of room heater have shining coverd metal surfaces to radiate the maximum amount of heat possible with the current structure of its radiator.
Adding an extra length of shaft on the existing shaft to take extra pulleys will put an extra load on the bearings supporting the shaft. In the long term this would shorten the life of the bearings. The makers might be able to supply more information like the side-load specification for the bearings. If in doubt support the outer end of the shaft.
It is a fuse, a piece of metal wire, usually in a glass tube, that can only just carry the maximum allowed current. A current greater than the maximum allowed will melt the wire.
A shaft sleeve is a piece of metal tubing placed over the shaft to protect as it passes through the packing area.
Anywhere that the mineral or metal is not close to the surface, requiring that a shaft be dug to get to it.
The condition for maximum velocity is acceleration equals zero; dv/dt = a= o.
So it doesn't break.
Forged steel
Metal golf shafts are made of steel.
The maximum efficiency condition in distribution transformer is said to be occurred when iron loss = copper loss
iunno
The metal would tend to contract in size. One technique to remove a gear from a shaft is to cool the shaft while heating the gear. The shaft contracts a bit while the gear expands a bit which can make the gear easier to remove. Also, dry ice (CO2) would not oxidize metal as water ice (H2O) would.
Use an easy-out of harder metal after drilling a small hole with harder metal.
I believe you want to know the MINIMUM bending radius of sheet metal. The maximum bend would be 180 degrees.
The gripper shaft is a rubber, leather, or textured metal part between the point and the fletching{ feathers or plastic fins], on the body of the dart.