0
Mazda 1987 truck will not shift into any gear but reverse?
Kathymcfarland1961
Well you have a strange issue. Being the trans will not shift into any but reverse would point to the clutch being toast. Normally if the truck will not shift is the slave clyinder or even the clutch master or throw out bearing gone. To rule out the the throw out did it noise while the truck was in neutral and even while in gear.If either apply may be the throw out is gone, but sounds 100% clutch is gone. If the truck will shift into soley reverse then this would rule out the slave, and clutch master cyldr and even the throw out in most cases due to the it is moving the fork to engage the clutch and the surface of the clutch is worn to it's life except reverse due to it is not used as much. I recommend a new clutch and replace the throw out bearing and would be a good idea to replace the pilot bearing and go ahead and do the rear main seal even if its not leaking if its got lots of miles, plus the age would make me do it being you have the trans pulled out.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What is theBiggest Mazda B-Series motor for a 1987 truck?
2.6L (2555cc)
Where is the clutch located on a 1987 Mazda B2600 Truck?
Its Located Rite Behind The Engine. STUPID!!!!
Will a 1992 Mazda B2200 pick up truck body be compatible with a 1987 Mazda B2200 pick up truck engine?
The Mazda B2200 truck body did not change much, if at all between 1986 and 1993. There should be no differences in the shape of the engine compartment. -Kyrasis6 Owner of Mazdatruckin.com
Will a starter motor from a 1987 Toyota Truck work on a 1987 Mazda B2000 Truck?
NO the mazda and toyota are two totally different trucks.The starters are designed based on engine and transmission design.This part is specific and can vary based on a automatic vs a manual even on the same brand and year model.
What causes the parking lights to come on in a 1987 Nissan truck when switched off?
Faulty switch on the stalk on steering column, had it do that to me on a mazda.
Diagram ignition wiring 1987 Mazda pickup?
Color coded instructions on how the wiring should go in my pickup truck ignition
How do you fix the reverse lights on a 1987 Nissan Pathfinder when all the other lights and fuses work but when you shift in reverse you get no reverse lights?
Try bypassing the reverse light switch that plugs into the transmission. If your reverse lights come on, voila! Problem solved. Buy a new switch.
How do you replace EGR on 1987 Mazda B2200 Truck?
This has been answered and do a seach and it will take you step by step and word it just as you placed your question about it!
Why does 1987 Mazda truck miss fire when cold start?
Start with a good tune up. Could be a bum spark plug or spark plug wire.
Where is the fuel pump in a 1987 Mitsubishi Truck?
where is the fuel pump in a 1987 Mitsubishi Truck
When was The Shift Key created?
The Shift Key was created in 1987.
Will a 2.8 liter v6 engine work in a 1987 Mazda b2200 truck?
I too am looking for the answer to this question, the 2.2L is too costly to build. And I seem to have bad luck with making a rod know in them.
