Best Answer

Loosen the 17mm bolt in the middle of the pulley. Loosen the belt tensioner, and the pulley should slide off with a little help. Make sure to nothing the little key-way that lines the pulley up.

User Avatar

Wiki User

โˆ™ 2011-12-10 20:46:21
This answer is:
User Avatar
Study guides
See all Study Guides
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Mazda mx3 crankshaft pulley removal
Write your answer...
Related questions

Is the crankshaft bolt right or left hand thread on the 1992 MAZDA MX3 1.6l sohc?

Right hand thread

Head gasket bolt torque specs for a Mazda mx3?

What are the head bolt torque specs for a mazda mx3 1600

When was the Mazda MX3 first produced?

The Mazda MX3 was first produced in 1991. It was introduced at the Geneva Motor Show in March of 1991. The MX3 was produced until 1998, when production was halted.

Will a 1994 Mazda mx3 dash fit in a 1992 Mazda mx3?

yes, you will have to remove all the plastics from the 94 and put them into the 92, as well as the wiring.

How do change brake pads on Mazda mx3?

well i just changed the brakes on my Mazda mx3 what you do is take the 2 pins out of the calipers which is holding the pads in place and then you are able to remove the pads

How do you set timing on a 1995 Mazda MX3?

This is done the same as the 1995 Mazda MX6. The answer is posted.

How do you change the thermostat on a 1993 Mazda mx3?

waste of time

Were is the thermostat in 92 Mazda mx3?

what size is the motor 1.8 liter

How to replace a fuel filter on the 1994 Mazda mx3?

its on the fire wall

How does the fuel regulator on a Mazda mx3 work?

By regulating the fuel pressure

Did a 93 Mazda MX3 come out 1.6liter and manual transmission?


What do you do when the automatic seat bealt is stuck and will not move on a Mazda mx3 1993?

Mazda has a recall on their seatbelts for some models for this reason. ask a Mazda dealer if your model has the seatbelt recall. I believe the 92 mx3 has a recall for the auto seatbelts, but i am not sure about 93. Look into it though and they might fix it for free!

Can a ignition control module cause my 1993 Mazda mx3 to run rough like its misfiring or what electrical component can cause it to run rough like its misfiring?

What causes my Mazda mx3 to turn off while driving down the road.

What is the flasher box in the Mazda mx3?

The flasher box in the Mazda MX3 is the plug in that controls the flashers for the turn signals and also the hazard lights. This part is located under the dash on the driver's side, just above the brake pedal area.

Value of 2006 mx3?

The last year Mazda made the MX3 was in 1996....... so a 2006 would be really expensive! ;) I guess you are asking about a different car

Where is the fuel filter located on a 92 Mazda MX3?

Under the back seat

Where is ecu for Mazda mx3?

its located on the floor behind the consol underneath the dash

Why does my 1992 Mazda MX3 V6 1.8l have no spark?

bad ignitor or coil .

How many quarts of oil does a Mazda mx3 need?

3 1/2 quarts

HELP i need to find the Fuse box in a 1997 Mazda mx3 1.8 V6?

MAZDA MX-3 was stopped production in 1995, perhaps it is another vehicle... MAZDA MX-3 was stopped production in 1995, perhaps it is another vehicle.. They didn't stop production of MX3 in 1995, I have a 1997 MX3. The main fuse box is under the bonnet just to the right hand side of the battery. The other fuse box is in the drivers footwell by the door.

How do you clear drain holes on a Mazda mx3 sunroof?

I found the answer here:

Mazda mx3 is overheating has no cooling leak - how can you fix it?

with my 95 mx3 i was having the same problem all i did was adjusted the angle of the radiator and the over heating problem stopped id try that

Which way does the front axle nut turn on a Mazda mx3?

lefty loosie righty tighty

Where is the intake air temperature sensor on 1995 Mazda mx3?

In mass air flow sensor.

In What Order Do You Put Spark Plug Wires on a 1993 Mazda mx3 4 cylinder?