For exact spec refer to service manual if figure is not located on rotor.
Brake discs or rotors need only be changed if they are scored or below minimum thickness. Pads will typically need to be changed about every 40,000 kms or so. Inspect for wear at least twice a year.
replace front brake discs and pads.
Remove the front tires and wheels. Remove the brake assembly. Tap on each rotor disk to loosen them. Slide the rotor disk off. Reverse the process to install the new rotor disk.
The minimum brake rotor thickness for the front and back rotors on a 1992 Honda Accord is 21mm. Rotors which are below this thickness will not offer adequate or reliable braking.
The minimum front brake rotor thickness is three aids of an inch. When the rotor does not have the minimum thickness the auto mechanic replacing the brakes can not use the rotor.
Minimum disc thickness vented front 24.6mm .Minimum disc thickness rear 16.6mm. min pad thickness front & rear 1mm
By going to the nearest service!
The minimum thickness or a front brake rotor to be turned is one quarter of an inch. If the brake rotor is less than a quarter of eight inch. It must be discarded.
What should the thickness be on the front brake lining for ford ranger 2010
It is important to have all the parts in a car in the best condition. The minimum front brake rotor thickness for this car is 21.4 millimeters or 0.843 inches.
The minimum thickness number should be cast into the rotor.
The brake rotor minimum thickness is .060 This applies to either the 2.3CL or 3.0CL, front or rear rotors. Seems awfully thin for a brake rotor, doesn't it? Other sources say .83 in. (21mm)front, .35 in. (9mm) rear [AcuraFixerDave] That rotor thickness is probably the BRAKE PAD thickness minimum, not including the steel backing plate [AcuraFixerDave].