0
Mitsubishi Montero sport coolant leak on passenger side of block?
Wiki User
∙ 14y ago
well on the back of the heads, there is a y pipe that lead to one pipe on the passenger side. "water out let pipe", the two pipes seal by compression fit using an o ring. mine is leaking there right now. it was hard to see and will be harder to get to.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the coolant temp sensor 1995 ford E250 4.9l?
On the passenger side of the block at the rear of the motor.
Is there an engine block coolant drain plug on a 2006 Chevrolet Express 3500 6.0 L V8?
There are block coolant drains on both sides of the block. Drivers side block drain is towards the front and the passenger side is towards the rear. They take a large allen wrench to unscrew.
What is the water pump used for in a car?
To circulate coolant through the engine block, radiator and passenger compartment heater core.
Can you put a knock sensor on a 1979 Chevy 350 block?
YES. If you look at the passenger side of the engine block just in front of the starter you will see a small plug that is screwed into the side of the block. That is a coolant drain plug so you can get all the coolant out of the block. Remove it and screw the knock sensor in it's place.
When 1998 Mitsubishi montero is left idling there is no heat output but when in drive and moving heat flows. Is this normal for this vehicle?
No, I would suspect a stuck open thermostat, a failing (worn) water pump or clogged heater core. Also chedk for a sticking heater control valve in the coolant circuit if fitted. It could also be a internally swelled heater hose from the block to the heater core blocking proper coolant flow..
How do you get the water out of the engine block for a Chevy Blazer?
Assuming this is a 4.3 engine, remove the block coolant drain plugs. There is one on each side of the block. The passenger side is towards the front of the block and the drivers side is towards the back.
Mitsubishi eclipse 1997 no fire in to spark plugs what problems not starter the engine?
check your sensor on the back of the engine block and under the intake manifold, passenger side. check your sensor on the back of the engine block and under the intake manifold, passenger side.
Where are the freeze plugs located in a 1992 Mitsubishi Montero?
If this still has the factory motor it should be either a 3.0 V6 or a 4 cyl. Both of them should have the freeze plugs located in the side of the block. It is identifiable by the circle shaped "cups" inserted into the side of the block.
How do you install an engine block heater 2006 Chevy trail blazer V6-4.2L?
Drain coolant from radiator and engine block Remove passenger's side rear freeze plug and replace with block heater kit
Where is the thermostat located on a 1994 Mitsubishi Mirage?
Follow the top radiator hose back to the engine block. The thermostat is usually behind the housing that connects the radiator hose to the engine block. To be more specific Its on a housing on the passenger side of the engine block.
Where located the drain hose in a Mitsubishi eclipse 2000 gt?
If you mean drain holes for coolant... There is one located at bottom of the radiator. And two more on each side of the engine block.
Where is the coolant drain plug on the engine block for an 02 Tacoma Prerunner?
The 2002 Tacoma engine block will have two coolant drain plugs on each side of the block. The coolant drain plugs will be near the front and the rear of the engine block.
